User's Manual
Table Of Contents
- 1. Introduction
- 2. Definitions
- 3. Spider SAS Overview
- 4. Precautions for use and maintenance
- 5. Cleaning
- 6. User profile
- 7. General description
- 8. Patient Use
- 9. How to pair Spider SAS (Windows)
- 10. Starting a recording with HookUp RS
- 11. Starting recording: anonymous mode
- 12. Stopping a recording
- 13. Software, hardware and accessories
- 14. Technical specifications
- 15. Appendix 1: Patient recommendations
- 16. Appendix 2: electromagnetic compatibility
- 16.1. Guidance and manufacturer's declaration
- 16.2. Guidance and manufacturer's declaration: cable length
- 16.3. Guidance and manufacturer's declaration: electromagnetic emissions
- 16.4. Guidance and manufacturer's declaration: magnetic and electromagnetic immunity
- 16.5. Guidance and manufacturer's declaration: electromagnetic immunity, portable RF equipment
- 16.6. Spider SAS and mobiles (recommendations)
10. STARTING A RECORDING WITH HOOKUP RS
HookUp RS is the programming software to set-up, initialize and start Spider SAS. It allows
to quickly review the parameters of the recording and the signal quality before starting the
recording.
There are 2 recording modes:
― SAS mode: ECG + SAS recording for 1 or 2 nights if PhysioHub is connected to the
Spider SAS when launching HookUp RS
― Holter mode: 24 or 48 hours continuous ECG only if PhysioHub is not connected to the
Spider SAS when launching the HookUp RS
GENERAL DESCRIPTION
➊ Setup Menu [Setup]
➀ Threshold SpO2 [Threshold SpO
2
]
Value can be adjusted by clicking on the dropdown list (see above). This function just modifies
the position of the blue line of the [SpO
2
– Plethysmo] windows (see § 10.5).
10.1.
10. STARTING A RECORDING WITH HOOKUP RS
SPIDER SAS – PHYSIO HUB – HOOKUP RS – U908F 35