User's Manual
Table Of Contents
- 1. Introduction
- 2. Definitions
- 3. Spider SAS Overview
- 4. Precautions for use and maintenance
- 5. Cleaning
- 6. User profile
- 7. General description
- 8. Patient Use
- 9. How to pair Spider SAS (Windows)
- 10. Starting a recording with HookUp RS
- 11. Starting recording: anonymous mode
- 12. Stopping a recording
- 13. Software, hardware and accessories
- 14. Technical specifications
- 15. Appendix 1: Patient recommendations
- 16. Appendix 2: electromagnetic compatibility
- 16.1. Guidance and manufacturer's declaration
- 16.2. Guidance and manufacturer's declaration: cable length
- 16.3. Guidance and manufacturer's declaration: electromagnetic emissions
- 16.4. Guidance and manufacturer's declaration: magnetic and electromagnetic immunity
- 16.5. Guidance and manufacturer's declaration: electromagnetic immunity, portable RF equipment
- 16.6. Spider SAS and mobiles (recommendations)
Spider SAS is recognized by the BTLE interface as {MicroPort Sensor BLE 05}. Click on the
icon (framed in purple above) to pair Spider SAS with the computer. If a password is required
type "0" or "000000".
Spider SAS paired successfully with the computer. Pairing can be checked with Device
Manager (see below).
The Bluetooth key must be installed according to the instructions of the manufacturer of BTLE
interface (see left). To check the BTLE adapter was correctly installed, on the desktop, right
click on the icon {My computer} then select consecutively {Properties} ⇨{Hardware} ⇨{Device
manager ❶} the BTLE adapter should be displayed ❷.
NATIVE BLUETOOTH INTERFACE
This interface is generally used for laptops equipped with BTLE embedded chipset.
NOTE: The pairing operation is similar to BTLE Belkin interface. Spider SAS must be
switched on in order to pair successfully.
9.3.
9. HOW TO PAIR SPIDER SAS (WINDOWS)
SPIDER SAS – PHYSIO HUB – HOOKUP RS – U908F 31