User's Manual

➐ [Shutdown] and [Start] buttons respectively for stopping the recording and beginning the
recording
NOTE: To stop the recording, Spider SAS must be paired with and connected to the PC.
➑ Tabs:
[ECGs]/: 2 ECG channels collected with RC013 or RC032, respectively short and long patient
cable
[Belts – Respi]
1st channel for nasal pressure (Respiration)
2nd channel for Thoracic effort (Belt)
3rd channel for Abdominal effort (Belt)
[SpO
2
– Plethysmo]
1st channel for Oxygen saturation (%)
2nd channel for plethysmography curve
➒ Cursor to adjust the amplitude of the ECG signal displayed in graphic areas ➓ and ⑪. The
cursor does not modify the gain of the recorded signal.
⑫ Colored bargraph to indicate quality of impedance of the signal displayed in graphic areas
➓ and ⑪. (See § 10.3.1)
➓ and ⑪ Graphic areas:
Display signals captured by electrodes and sensors depending on the tabs selected (see ➑).
LAUNCHING HOOKUP RS
Click on the HookUp RS shortcut created on the desktop during the installation of the
software. The screen shown below is then displayed.
10.2.
10. STARTING A RECORDING WITH HOOKUP RS
SPIDER SAS – PHYSIO HUB – HOOKUP RS – U908F 37