User's Manual

12 – ENGLISH
5. USING YOUR SMARTVIEW MONITOR
The Sorin SMARTVIEW monitor works automatically. Therefore, you will
have no interaction with it except at installation and only on your doctor’s
request.
5.1. SETTING-UP YOUR SMARTVIEW MONITOR
In order to perform the installation of your SMARTVIEW monitor in a quick,
easy and safe way, we recommend you to call our technical assistance (see
toll-free phone numbers at the end of this manual). Our technicians will
assist you. It is free and takes little time.
Step Operation
1
Take all the items out of the box.
2
Place your SMARTVIEW monitor
in a stable position,
preferably on your nightstand, as close as possible to the
side of the bed you usually sleep on.
3
Remove the power adaptor from the little white box and
plug the end of the cable with the orange mark into the
appropriate inlet in the SMARTVIEW monitor identified
with the same orange mark.
4
Plug the power supply
block into the mains. A green light
turns ON immediately on this block.
5
You should observe the following:
The status light turns stable amber for around 45 seconds
and then turns green. Your SMARTVIEW monitor is now
ready for the next step: Communication.
6
The Patient Initiated Transfer
button is now flashing
green. It will continue flashing as long as you do not press
this button.