User's Manual

– ENGLISH

Remove the power adaptor from the little white box and

plug the end of the cable with the orange mark into the

appropriate inlet in the SMARTVIEW monitor identified

with the same orange mark.

Plug the power supply block into the mains. A green light

turns ON immediately on this block.

You should observe the following:

The status light turns stable amber for around 45 seconds

and then turns green. Your SMARTVIEW monitor is now

ready for the next step: Communication.

The On-Demand button is now flashing green. It will continue

flashing as long as you do not press this button.

To operate properly, your SMARTVIEW monitor

should always be connected to your phone line and

the main power outlet.

5.2. COMPLETE THE INSTALLATION WITH

COMMUNICATION SETUP

At this stage, your SMARTVIEW monitor will need to “talk” with your

Sorin CRM implanted device. You will not feel anything as it is fully

independent of your clinical treatment.

Press the On-Demand button gently until you feel a click. You will see

the On-Demand button constant green for between 30 seconds and 1

minute. Wait until the green light turns completely OFF.

Your SMARTVIEW monitor is fully operational and your doctor has

already been notified that the installation has run successfully. Your

Sorin CRM implanted device is now being monitored.