User's Manual
Table Of Contents
- 1. Warnings and precautions
- 2. Warranty conditions
- 3. The programmer system
- 4. The programmer tablet
- 5. The programmer software
- 6. The docking station
- 7. The inductive programming head
- 8. The radio frequency (RF) link
- 9. The ECG
- 10. The printer
- 11. Maintenance
- 12. Guidance and manufacturer's declaration
- 12.1. Radio equipment emission
- 12.2. Recommended separation distances according to the maximum output power of the communications equipment
- 12.3. Cable length
- 12.4. Electromagnetic emissions
- 12.5. Magnetic and Electromagnetic Immunity
- 12.6. Electromagnetic Immunity, Portable Radio Frequency Equipment
- 12.7. Raw materials
- 13. Technical data
- 13.1. Conformity of the programmer
- 13.2. US Federal Communications Commissions (FCC) and Industry Canada
- 13.3. Essential performances
- 13.4. Power supply
- 13.5. Dimensions programmer tablet
- 13.6. Dimensions docking station
- 13.7. Dimensions inductive programming head
- 13.8. Use constraints
- 13.9. Storage constraints
- 13.10. System specifications of the programmer
- 14. Explanation of symbols
- 15. Glossary
2. WARRANTY CONDITIONS
For detailed information about the compatibility of programming devices and implantable
patient devices, please refer to the Device-Compatibility-Matrix that is available under the
reference number UA193 at www.microportmanuals.com.
The manufacturer agrees to replace any defective material.
If a technical problem occurs, please contact your company representative or the company’s
service department.
WARNING: Never modify the configuration of the programmer. Do not install any software
on the programmer.
The programmer contains no internal parts that can be repaired by the user. In the event of
a problem, please return the programmer to your company representative in the condition in
which it was received.
The manufacturer waives all responsibility if a malfunction occurs following manipulation by
the user as described above.
2. WARRANTY CONDITIONS
SmartTouch – UA10412A 7