User's Manual
Table Of Contents
- 1. Warnings and precautions
- 2. Warranty conditions
- 3. The programmer system
- 4. The programmer tablet
- 5. The programmer software
- 6. The docking station
- 7. The inductive programming head
- 8. The radio frequency (RF) link
- 9. The ECG
- 10. The printer
- 11. Maintenance
- 12. Guidance and manufacturer's declaration
- 12.1. Radio equipment emission
- 12.2. Recommended separation distances according to the maximum output power of the communications equipment
- 12.3. Cable length
- 12.4. Electromagnetic emissions
- 12.5. Magnetic and Electromagnetic Immunity
- 12.6. Electromagnetic Immunity, Portable Radio Frequency Equipment
- 12.7. Raw materials
- 13. Technical data
- 13.1. Conformity of the programmer
- 13.2. US Federal Communications Commissions (FCC) and Industry Canada
- 13.3. Essential performances
- 13.4. Power supply
- 13.5. Dimensions programmer tablet
- 13.6. Dimensions docking station
- 13.7. Dimensions inductive programming head
- 13.8. Use constraints
- 13.9. Storage constraints
- 13.10. System specifications of the programmer
- 14. Explanation of symbols
- 15. Glossary
11. MAINTENANCE
CLEANING
The programmer and its accessories should never be immersed in any liquid or cleaned with
sterilization products. Avoid spilling liquid on any part of the programmer system.
In order to clean the following items:
― SmartTouch Tablet
― SmartTouch docking station
― CPR3H and Dongle
1. Visually inspect them for contaminants and remove loose material with a dry or water-
moistened cloth.
2. Then clean them with a tissue pad or a wipe moistened with one of the following agents:
― Ethyl alcohol
― Isopropyl alcohol
The above-mentioned agents have been tested by the manufacturer, and validated to neither
cause physical damage nor degradation to any part of the programmer.
For information on how to clean the RF Link, please refer to the associated user manual.
For information on how to clean the surface ECG, please refer to the associated user manual.
For information on how to clean the printer, please refer to the associated user manual.
DISINFECTION AND STERILISATION
All parts of the programmer system are delivered non sterile, and cannot be disinfected or
sterilized. The inductive programming head must be covered with a sterile sleeve when
using in sterile environments.
SYSTEM END-OF-LIFE
At their end of life, the programmer, its accessories and/or battery shall be sent back to the
manufacturer for recycling.
SPARE PARTS
Description Reference
SmartTouch tablet V167
SmartTouch docking station V174
Inductive programming head (CPR3H) GB78
Dongle (USB adapter for CPR3H) G999
Radio Frequency Link (Orchestra Plus Link) KA351
Smart ECG K379
11.1.
11.2.
11.3.
11.4.
11. MAINTENANCE
24 SmartTouch – UA10412A