User's Manual
Table Of Contents
- 1. Warnings and precautions
- 2. Warranty conditions
- 3. The programmer system
- 4. The programmer tablet
- 5. The programmer software
- 6. The docking station
- 7. The inductive programming head
- 8. The radio frequency (RF) link
- 9. The ECG
- 10. The printer
- 11. Maintenance
- 12. Guidance and manufacturer's declaration
- 12.1. Radio equipment emission
- 12.2. Recommended separation distances according to the maximum output power of the communications equipment
- 12.3. Cable length
- 12.4. Electromagnetic emissions
- 12.5. Magnetic and Electromagnetic Immunity
- 12.6. Electromagnetic Immunity, Portable Radio Frequency Equipment
- 12.7. Raw materials
- 13. Technical data
- 13.1. Conformity of the programmer
- 13.2. US Federal Communications Commissions (FCC) and Industry Canada
- 13.3. Essential performances
- 13.4. Power supply
- 13.5. Dimensions programmer tablet
- 13.6. Dimensions docking station
- 13.7. Dimensions inductive programming head
- 13.8. Use constraints
- 13.9. Storage constraints
- 13.10. System specifications of the programmer
- 14. Explanation of symbols
- 15. Glossary
7. THE INDUCTIVE PROGRAMMING HEAD
The programming head provides inductive communication between the programmer tablet
and the implanted cardiac device.
The programmer tablet must only be used with a ‘CPR3H’ inductive programming head.
COMPONENTS
Inductive programming head Dongle (USB adapter for CPR3H)
1) Nominal mode button 3) Serial connector
2) Locator LEDs 4) USB connector
The blue marking indicates that the USB connector of the dongle needs to be connected to
the USB 3.0 port of the tablet
GENERAL INFORMATION
The CPR3H inductive programming head must only be connected to the USB 3.0 port of the
programmer tablet via the dongle.
1. Connect the dongle with the inductive programming head before connecting the dongle
to the programmer tablet. For more information on how to connect the inductive
programming head with the dongle please refer to chapter 4.3.
2. The head is automatically turned on when the programmer tablet is switched on.
3. An automatic test is run when the head is turned on in order to verify that it is operating
properly.
4. During the test the yellow and green LEDs located on top of the programming head
switch on.
5. The programming head is functional when the yellow LED is on.
The inductive programming head is used to:
7.1.
7.2.
7. THE INDUCTIVE PROGRAMMING HEAD
18 SmartTouch – UA10412A