User's Manual
Table Of Contents
- 1. Warnings and precautions
- 2. Warranty conditions
- 3. The programmer system
- 4. The programmer tablet
- 5. The programmer software
- 6. The docking station
- 7. The inductive programming head
- 8. The radio frequency (RF) link
- 9. The ECG
- 10. The printer
- 11. Maintenance
- 12. Guidance and manufacturer's declaration
- 12.1. Radio equipment emission
- 12.2. Recommended separation distances according to the maximum output power of the communications equipment
- 12.3. Cable length
- 12.4. Electromagnetic emissions
- 12.5. Magnetic and Electromagnetic Immunity
- 12.6. Electromagnetic Immunity, Portable Radio Frequency Equipment
- 12.7. Raw materials
- 13. Technical data
- 13.1. Conformity of the programmer
- 13.2. US Federal Communications Commissions (FCC) and Industry Canada
- 13.3. Essential performances
- 13.4. Power supply
- 13.5. Dimensions programmer tablet
- 13.6. Dimensions docking station
- 13.7. Dimensions inductive programming head
- 13.8. Use constraints
- 13.9. Storage constraints
- 13.10. System specifications of the programmer
- 14. Explanation of symbols
- 15. Glossary
To interrogate radiofrequency-enabled implanted devices connect the Radio Frequency (RF)
Link to the USB 2.0 port on the left side of the programmer tablet.
STARTING THE PROGRAMMER
1. Be sure to follow the steps described in chapter 4.2. and 4.3. before using the
programmer.
2. Start the programmer with a short press on the power on/off button in the top right corner
of the tablet.
3. The welcome window will be displayed on the screen.
The software boots automatically when the programmer starts up.
USING THE TOUCH SCREEN
The programmer tablet is equipped with capacitive touch screen technology. Simply tap the
screen with your fingers or a stylus for capacitive touch screens in order to select tabs, files
and text fields, or to run applications. The tablet screen will automatically switch to a black
screen saver after a few minutes not in use (a Bluetooth LED in the upper left corner of the
tablet is still lit up). Wake up the tablet programmer by tapping on the screen.
SWITCHING OFF THE TABLET
1. Press the power on/off button in the top right corner of the tablet and hold it down for 1
second (Bluetooth LED in the upper left corner of the tablet goes off).
2. There is a guard around the power on/off button to avoid a software interruption due to a
handling error.
3. It is not possible to switch the programmer to standby mode during an interrogation
session.
4. The tablet will automatically switch to standby mode when remaining unused in the
‘Manager’ software. In order to restart the tablet, press briefly on the power on/off button.
For information about the programmer software, please see chapter 5.
4.4.
4.5.
4.6.
4. THE PROGRAMMER TABLET
SmartTouch – UA10412A 13