User's Manual
Table Of Contents
- 1. Warnings and precautions
- 2. Warranty conditions
- 3. The programmer system
- 4. The programmer tablet
- 5. The programmer software
- 6. The docking station
- 7. The inductive programming head
- 8. The radio frequency (RF) link
- 9. The ECG
- 10. The printer
- 11. Maintenance
- 12. Guidance and manufacturer's declaration
- 12.1. Radio equipment emission
- 12.2. Recommended separation distances according to the maximum output power of the communications equipment
- 12.3. Cable length
- 12.4. Electromagnetic emissions
- 12.5. Magnetic and Electromagnetic Immunity
- 12.6. Electromagnetic Immunity, Portable Radio Frequency Equipment
- 12.7. Raw materials
- 13. Technical data
- 13.1. Conformity of the programmer
- 13.2. US Federal Communications Commissions (FCC) and Industry Canada
- 13.3. Essential performances
- 13.4. Power supply
- 13.5. Dimensions programmer tablet
- 13.6. Dimensions docking station
- 13.7. Dimensions inductive programming head
- 13.8. Use constraints
- 13.9. Storage constraints
- 13.10. System specifications of the programmer
- 14. Explanation of symbols
- 15. Glossary
Leave the tablet to charge for a minimum of 2 hours.
If the battery performance decreases due to aging, programmer maintenance will be required.
Please contact your company representative.
SETTING UP THE SYSTEM
Before using the programmer follow the steps below:
Step 1: Installing the tablet battery
1. Align and insert the battery at the rear of the programmer tablet.
2. Secure the battery by moving the mechanical lock to the “locked” position.
Step 2: Charging the programmer tablet
Please refer to the preceding chapter 4.2.
Step 3: Installing the programmer tablet
To ensure proper operation of the programmer tablet, place it on a secure and stable surface
or in the docking station. When using the tablet with the docking station, make sure the
tablet is correctly inserted and locked into the docking station. For more information about
the docking station please see chapter 5. Inappropriate installation of the equipment may
prevent it from functioning correctly!
Step 4: Connecting the inductive programming head (CPR3H)
1. Securely connect the serial connector of the inductive programming head with the dongle
(for detailed information about the CPR3H inductive programming head and dongle
please see chapter 7).
2. Tighten the fixation screws between the inductive programming head and the dongle.
3. Open the I/O ports cover at the left side of the programmer tablet and connect the dongle
to the USB 3.0 port (blue marking). See figure below.
To ensure a stable telemetry operation the inductive programming head must be connected
to the USB 3.0 port (blue marking).
To maintain a stable telemetry connection the dongle must always be tightly attached to the
inductive programming head and the USB 3.0 port of the programmer tablet.
4.3.
4. THE PROGRAMMER TABLET
12 SmartTouch – UA10412A