3-868-315-11 (1) FM/AM Cassette Car Stereo Operating Instructions Owner’s Record The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. XR-1100 Serial No. For installation and connections, see the supplied installation/connections manual.
US Warning Welcome! This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Precautions • If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. • If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. • If no sound comes from the speakers of a 2-speaker system, set the fader control to the center position. • If your car is equipped with a power antenna, note that it will be automatically extended while the unit is operating.
Cassettes longer than 90 minutes The use of cassettes longer than 90 minutes is not recommended except for long continuous play. The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. Table of Contents Location of controls ................................................. 5 Getting Started Setting the clock ..................................................
Location of controls DIR A MEM D-BASS TUNER SEEK MANU SOUND OFF LOCAL ATA 1 DSPL 2 3 4 5 6 XR-1100 US Refer to the pages for further details.
4 Press the DSPL button momentarily. Getting Started The clock activates. Setting the clock The clock has a 12-hour digital indication. For example, setting it to 10:08 1 Display the time. (Press the DSPL button during unit operation.) 2 Press the seconds. DSPL button for more than two The hour digit blinks. US Set the hour digits. to go forward to go back 3 Press the SOUND button momentarily. The minute digits blink. Set the minute digits.
Cassette Player Fast-winding the tape Direction indicator* Listening to a tape To advance To rewind N After inserting the cassette, playback will start automatically. n To resume playback, press the other fastwinding button partially until the locked button is released. To change the tape direction, press both the m and the M buttons at the same time. * The n or N indicator will flash while fastwinding the tape. DIR The side facing up is being played. The side facing down is being played.
Tuning in by adjusting the frequency — Manual tuning Radio 1 A MEM Searching for stations automatically — Automatic tuning 1 TUNER 2 Select the desired band. A MEM TUNER Select the desired band. FM1 t FM2 t AM t FM1 FM1 t FM2 t AM t FM1 Press and hold either side of the SEEK/ MANU button. Release the button when the desired station is received. For higher frequencies SEEK MANU 2 US Press either side of the SEEK/MANU button momentarily to search for the next station (automatic tuning).
