Operating Instructions

Others

On-screen display

Remote control

The picture is too dark. c Adjust the “Contrast” or “Brightness” of the Picture menu

properly. (1 page 46)

The picture is not clear. c Adjust the focus. (1 page 25)

c Condensation has accumulated on the lens. Leave the projector

for about 2 hours with the power on.

The picture flickers. c For pictures from a computer, activate “APA” and adjust the

current input signal.

c Adjust “Phase” for “Adjust Signal” in the Screen menu

properly. (1 page 51)

The color of characters or

the picture is not

appropriate.

c Select the desired color registration in “Panel Alignment” of

Installation menu (1 page 57).

Image is left on the screen.

(image retention)

c When high contrast non-moving images are displayed for a long

period of time, there may be some image retention on the

screen. This is only a temporary condition. Turning off the

power for a while will eliminate the retained image.

Symptom Cause and Remedy

On-screen display does not

appear.

c Set “Status” in the Setup menu to “On.” (1 page 52)

c Check if the ON/STANDBY indicator should light in green.

The model name does not

disappear from the screen.

c The display mode of the projector may be set at the time of

purchase. Consult with your local dealer or qualified Sony

personnel.

Symptom Cause and Remedy

The remote control does

not work.

c Batteries could be weak. Replace them with new batteries.

(1 page 10)

c Insert the batteries with the correct polarities. (1 page 10)

c If there is a fluorescent lamp near the remote control detector, the

projector may work improperly or inadvertently.

c Set “IR Receiver” to “Front & Rear” on the Installation menu

(1 page 56).