VH110 User guide
Contents Headset overview.........................................................................5 Introduction..................................................................................6 Charging........................................................................................7 Turning on and off........................................................................8 Pairing the headset......................................................................9 Pairing the headset with a phone...
1. 1 2 3 4 5 6 7 8 2. 3. 4. 3 This is an Internet version of this publication. © Print only for private use.
2 5. 3 1 6. 4 This is an Internet version of this publication. © Print only for private use.
Headset overview See illustration 1. 1 Ear speaker 2 Ear hook 3 Microphone 4 Volume keys 5 On/off key, Call key 6 Indicator light 7 Charger connector 8 Ear bud 5 This is an Internet version of this publication. © Print only for private use.
Introduction The VH110 Bluetooth™ Handsfree can be connected to any Bluetooth™ compatible device that supports the headset. This User guide focuses on use with a Sony Ericsson mobile phone. 6 This is an Internet version of this publication. © Print only for private use.
Charging Before using the headset for the first time, you need to charge it with the supplied charger for 8 hours (See illustration 2). The normal charging time is 2.5 hours. Use Sony Ericsson chargers only. 7 This is an Internet version of this publication. © Print only for private use.
Turning on and off To turn on the headset • Press and hold down until the indicator shows a steady green or red light. (If the light is red, the headset needs charging.) After 3 seconds, the light turns off and the headset is on. To turn off the headset • until the indicator shows a green or red light. (If the light Press and hold down is red, the headset needs charging.) After 3 seconds, the light turns off and the headset is off. 8 This is an Internet version of this publication.
Pairing the headset Pairing the headset with a phone To use the headset with a phone, you need to pair the headset with the phone. After successful pairing, the headset connects automatically to the phone as soon as the headset is turned on and within range. 1 2 3 4 5 6 7 8 To pair the headset with a phone Make sure the headset is turned off. Turn on the Bluetooth function in the phone. For instructions, see the phone User guide. Turn on Bluetooth visibility in the phone.
Putting on the headset • To put on the headset Slide the ear hook behind your ear and point the microphone towards your mouth. See illustration 3 and 4. You can use the headset with or without the ear hook. You can also use the headset either on the left or right ear. See illustration 5. 10 This is an Internet version of this publication. © Print only for private use.
Calling When you have paired the headset with your phone, you can make and receive calls as long as the headset is turned on. • To make a call Dial the number using the phone keys. The call is automatically activated in the headset. • To end a call Press the end call key. • To answer a call A signal indicates an incoming call. Press the call key. • To reject a call A signal indicates an incoming call. Press and hold down the call key. • To answer a second call Press the call key.
Battery A battery that has been infrequently used, or a new one, could have reduced capacity. You may need to recharge it a number of times. When the battery level is low, the indicator light flashes red and you hear a low beep. If you do not charge the headset, it turns off after 10 minutes. 12 This is an Internet version of this publication. © Print only for private use.
Cover See illustration 6. You can see the regulatory information on the headset cover. 13 This is an Internet version of this publication. © Print only for private use.
Resetting the headset Reset the headset if it behaves unexpectedly. Resetting the headset removes all information about paired devices. To reset the headset • Press and hold down for 10 seconds. To reset the headset to factory settings • Press and hold down key during pairing mode. 14 This is an Internet version of this publication. © Print only for private use.
Troubleshooting The headset is automatically turned off • • The battery level is too low. You hear a beep approximately 10 minutes before the headset turns off. Charge the battery. The headset turns off if you do not pair it with the phone within 10 minutes. Unexpected behaviour • Reset the headset. No connection to the phone Make sure the headset is charged and within range of the phone. We recommend a maximum distance of 10 metres (33 feet) with no solid objects in between.
FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any change or modification not expressly approved by Sony Ericsson may void the user's authority to operate the equipment.
Industry Canada Statement This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. 17 This is an Internet version of this publication.
Declaration of Conformity for VH110 We, Sony Ericsson Mobile Communications AB of Nya Vattentornet SE-221 88 Lund, Sweden declare under our sole responsibility that our product Sony Ericsson type DDA-0002031 and in combination with our accessories, to which this declaration relates is in conformity with the appropriate standards EN 300 328:V1.7.1, EN 301 489-7:V1.3.1, EN 301 489-17:V2.1.
