PCG-FX220/FX220K/FX240/FX240K/ PCG-FX250/FX250K/FX270/FX270K SERVICE MANUAL US Model Canadian Model S400 Illust : PCG-FX270K l a i t n e d i f n o C NOTEBOOK COMPUTER 9-872-227-11
Information in this document is subject to change without notice. Caution Markings for Lithium/Ion Battery - The following or similar texts shall be provided on battery pack of equipment or in both the Sony and VAIO are trademarks of Sony. Intel logo and Intel Inside logo are registered trademarks of Intel Corporation. Pentium MMX operating and the service instructions. is a trademark of Intel Corporation.
TABLE OF CONTENTS Section Title Page CHAPTER 1. REMOVAL 1-1. 1-2. 1-3. 1. 2. Section Title Page CHAPTER 2. SELF DIAGNOSTICS ......................... 2-1 Flowchart ......................................................................... 1-1 Main Electrical Parts Location Diagram ......................... 1-1 Removal ........................................................................... 1-2 Hood Keyboard Assy, Keyboard Unit ..............................
CHAPTER 1. REMOVAL 1-1.
1-3.Removal 1. Hood Keyboard Assy, Keyboard Unit 3M2X4 Special Head (Black) 4Pull it up sliding it to the right. 8M2X4 Special Head (Black) 6Hood Keyboard Assy q;Keyboard Unit 7 5 Four Claws 1 9 2 MBX-49 Board CN2004 MBX-49 Board CN1902 2.
3. Combination Drive, DVD-ROM Drive 1. FX240/FX240K/FX250/FX250K/FX270/FX270K Model 5Bracket CD-ROM R 3+B M2 (X2) (Gold) 4+B M2 (X2) (Gold) 8COMBO Drive 6Screw (M1.7) (X3) (Black) Claw 2Bracket (CD-ROM L) 1+B M2 (X2) (Gold) 7DVD-RW Door Assy 2. FX220/FX220K Model 3+B M2 (X2) (Silver) 5Bracket CD-ROM R 8DVD-ROM Drive 4+B M2 (X2) (Silver) 6Tapping screw (B1.
4. HDD, Door Battery 1M2X6 Special Head (X6) (Gold) 1Screw M3X4 (X2) (Gold) 3 3Bracket HDD 2FPC 50Pin (for HDD) MBX-49 Board CN2201 5HDD 4FPC 50Pin (for HDD) 2Screw M3X4 (X2) (Gold) 4Door Battery 5. Palm Rest Assy, Touch Pad, CNX-125 Board, Palm Rest Plate, Bracket Pad 3Pull it to the front slightly and raise to remove it. Palm Rest Assy 1M2X4 Special Head (Black) 7CNX-125 Board 9Touch Pad 4 8FPC (TP-CNX) PWS-13 Board CN4004 6FPC (SWX-PWX) 5Bracket Pad 4Remove by pressing to rear.
6. Display Assy, Hinge Cover 1Stand the LCD upright to the MBX-49 board. 7M2.6 Cross (Hole) Bind (Black) 3+B M2 (X2) (Gold) 9M2X6 Special Head (Gold) 4Plate ground q;+B 2X12 (Silver) qaM2X6 Special Head (Black) 2 qs 5M2.6 Cross (Hole) Bind (Black) Six Claws 6M2.6 Cross (Hole) Bind (X2) (Black) MBX-49 Board CN701 8Screw (M2), 0 Number P3 Kind (Black) qdClose simultaneously both left and right hinges approximately 90° in the direction of the arrow.
7. PWS-13 Board, Latch Detector 2M2X4 Special Head (X2) (Black) 6PWS-14 Board 5Latch Detector 1 3 MBX-50 Board CON22 4Two Claws 8.
9. Speaker Unit, SWX-73 Board 6M2X4 (X2) (Black) Note : When removing the speaker unit, be sure not to damage the hood keyboard. 4M2X4 (X5) (Black) SWX-73 Board CN301 SWX-73 Board CN302 7Speaker Unit 3 5SWX-73 Board SWX-73 Board CN303 8M2X4 (X2) (Black) 1 2 Note : To re-install it, align the notch of the speaker unit with the projection of the hood keyboard. 9Speaker Unit Notch Speaker Unit Notch Hood Keyboard Projection Projection Hood Keyboard 10.
. Modem Card (Removing from the bottom) 1M2X4 Special Head (Black) 2Modem Door 3M2 Grip (X2) (Black) 4Modem Card 5 Confidential PCG-FX220/FX220K/FX240/FX240K/ PCG-FX250/FX250K/FX270/FX270K (UC) 1-8
. LCD Section (FX270/FX270K Model) – Made by HI – 1. Bezel Housing Assy, LCD unit (15 inch) 1Cover Screw Side (15) (X3) 3Cover Screw Shaft 4+P 2.6X6 Lock Precision b Type3 (Black) 2M2X3 Special Head (X3) (Gold) Bezel Housing Assy a : claw part 7 3Cover Screw Shaft 2M2X3 Special Head (X3) (Gold) Cover Screw Side (15) (X3) c b How to release the claw a 4+P 2.
2.
13. LCD Section (FX220/FX220K/FX250/FX250K Model) – Made by HI – 1. Bezel Housing Assy, LCD unit (15 inch) 1Cover Screw Side (15) (X3) 3Cover Screw Shaft 4+P 2.6X6 Lock Precision b Type3 (Black) 2M2X3 Special Head (X3) (Gold) Bezel Housing Assy a : claw part 7 3Cover Screw Shaft 2M2X3 Special Head (X3) (Gold) 1Cover Screw Side (15) (X3) c b How to release the claw a 4+P 2.
2.
14. LCD Section (FX240/FX240K Model) – Made by HI – 1. Bezel Housing Assy (14 inch) 1Cover Screw Lower (X2) 2M2X4 Special Head (X2) (Black) b : claw part a 1Cover Screw Upper (X2) 2M2X4 Special Head (X2) (Black) 3 Bezel Housing Assy c b 4M2X4 Special Head (X5) (Black) 4M2X4 Special Head (X5) (Black) 7 How to release the claw a LCD Unit 5 6 Bezel Housing Assy Display Housing Assy a Display Housing Assy Pull the Bezel Housing Assy as shown to release the claw a.
2. Bracket LCD Left, Bracket LCD Right, LCD Unit (14 inch) 3+P M2x3 Lock (X4) (Gold) 5LCD Unit 1+P M2x3 Lock (X4) (Gold) 4Bracket LCD Left 2Bracket LCD Right 3.
1-4.Replacing the CPU NOTE: This computer uses either one of the two types of CPU socket. The CPU locking position and the lock-release position are different depending on the types of the CPU socket. 1. Socket type 1, 2 1. Removing the CPU 1 1 Insert a flat-blade screwdriver into the notch as shown in the illustration and rotate it so that the protrusion comes to the lock release position. 2 Pull the CPU gently upward to lift it out of the CPU socket.
2. Socket type 3 1. Removing the CPU 1 CPU 2 L O Protrusion Lock release position [O] CPU socket 1 Insert a flat-blade screwdriver into the notch as shown in the illustration and rotate it so that the protrusion comes to the “O” (lock release) position. 2 Pull the CPU gently upward to lift it out of the CPU socket. 2.
1-5. Replacing Various Connectors on the MBX-49 Board Replace the connectors of “5-5. Connector Section” as follows. 1. Removing the I/O Bracket When removing the connectors of reference numbers 164, 165 and 167 (refer to page 5-13), remove the I/O bracket first. +B 2X4 (X2) (Silver) I/O Bracket Screw (HEX) (X6) (Silver) MBX-49 Board 2.
1-6. DIP Switch Setting of the MBX-49 Board Set the DIP switch on the MBX-49 board (main board) to match with the LCD that is used in this computer, because several types of LCD are used as shown in the following table and the DIP switch setting differs depending on the LCD type. Name of LCD Part No. DIP switch setting FX270/FX270K HI 1-476-300-11 The upper position where ON indication is shown is the ON position . The lower position is the OFF position.
CHAPTER 2. SELF DIAGNOSTICS ATTENTION Please confirm “Self Diagnostics” method which will be informed you with distribution of “Self Diagnostics” software.
CHAPTER 3. BLOCK DIAGRAM CPU Volt Reg SO-DIMM Socket 2 TV Encoder CH7007A (LED Signal Include) LVDS CNX-126 1 Row# 0,1 i.Link TI TSB43AA22PD T Cardbus RICOH R5C476 II AHA 2 9 RJ-45 9 USB PORT2 Audio AC Link AD1881A FW82801 Ext.
CHAPTER 4.
CHAPTER 5. EXPLODED VIEWS AND PARTS LIST NOTE: The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. • The mechanical parts with no reference number in the exploded views are not supplied. • Items marked “ * ” are not stocked since they are seldom required for routine service. Some delay should be anticipated when ordering these items. • When two or more parts are shown in parallel, use the part described first as the main part.
5-1. Main Section Ref.No. 1 3 3 *8 *8 Part No. X-4623-780-1 4-640-837-31 4-640-837-22 4-651-706-21 4-651-706-01 Description ASSY BOTTOM (AM2) DOOR BATTERY DOOR BATTERY HEATSINK BOTTOM HEATSINK BOTTOM Ref.No. 71 72 72 74 * 76 Part No.
B34 B1 B1 B33 B1 128 156 B3 B1 22 I J G 30 J B32 B15 B3 A 25 K G B1 B15 N 60 B1 B34 19 63 24 B34 B34 12 H 171 15 169 B1 B10 20 153 B34 26 136 148 82 152 (FX220/FX220K Model) 27 21 B34 147 C F 46 L B7 B10 125 124 31 18 76 H B37 34 28 136 29 88 112 N 123 B4 164 166 B4 72 165 K I 20 B18 B36 B18 32 B10 76 157 33 B1 B4 B10 L B34 C 31 B10 71 167 11 159 B34 84 52 48 134 E 58 57 161 B10 34 162 B34 B31 56 B3 163 B14 (FX240/FX240
5-2. LCD Section (FX270/FX270K Model) – Made by HI – 226 224 234 B30 203 B22 235 206 234 208 B22 224 Ref.No. 201 202 203 206 207 Part No. 1-476-316-11 X-4623-380-1 X-4623-690-1 4-637-902-41 1-476-300-11 Description INVERTER UNIT HINGE LEFT 15 ASSY HOU,BEZEL 15H-Z (EXP) LATCH ASSY LCD 15SXGA (HI) (S) 208 212 213 214 214 4-637-903-01 X-4623-689-1 4-642-762-41 4-655-380-11 4-655-380-51 SPRING LATCH ASSY HOU,DISPLAY 15H-Z (EXP) COVER HINGE (15) (FX270)...LABEL ID (U) (FX270K)...
5-3. LCD Section (FX220/FX220K/FX250/FX250K Model) – Made by HI – 426 424 434 B30 403 B22 435 406 434 408 B22 424 407 Ref.No. 401 402 403 406 407 Part No. 1-476-316-11 X-4623-380-1 X-4623-690-1 4-637-902-41 1-476-186-12 Description INVERTER UNIT HINGE LEFT 15 ASSY HOU,BEZEL 15H-Z (EXP) LATCH ASSY LCD 15HI (S) 408 412 413 414 414 4-637-903-01 X-4623-689-1 4-642-762-41 4-655-380-41 4-655-380-81 SPRING LATCH ASSY HOU, DISPLAY 15H-Z (EXP) COVER HINGE (15) (FX220)...LABEL ID (U) (FX220K)...
5-4. LCD Section (FX240/FX240K Model) – Made by HI – 303 325 304 305 B8 B8 Ref.No. 301 302 303 304 305 Part No.
5-5. Connector Section Ref.No. 72 Fig. Part No. Description 4-651-709-41 (CH)...BRACKET IO 4-651-709-01 (JP)...BRACKET IO I/O BRACKET 72 164 1-779-745-21 JACK, DC DC IN connector 164 165 165 1-815-422-11 CONNECTOR (VERTICAL) USB connector 167 1-815-221-21 CONNECTOR, USB (VERTICAL) USB connector 167 ∗Before replacing the connector of reference number 164, 165 and 167, remove the I/O bracket. For the disassembling procedure, refer to page 1-17.
PCG-FX220/FX220K/FX240/FX240K/ PCG-FX250/FX250K/FX270/FX270K (UC) List of PCG-FX Series (As of May, 2001) Model Name Service Manual Part No.
