Operating Instructions

31
3 Press the + or – button to set the desired monitor
audio level, then press the SET button.
The setting is saved and retained even after the power
is tu
rned off.
Configuration menu
Procedure for portable diversity tuner (URX-P40)
This section describes each function and configurable
it
ems.
Underlined entries indicate factory default settings.
Selecting the group/channel (GP/CH)
The factory default setting varies depending on the
model.
For details, see “Setting the receive channel” (page 27).
Adjusting the monitor audio level
(PHONES)
Adjusts the monitor audio level for the headphones.
The factory default setting is 12.
For details, see “Adjusting the monitor audio level”
(page 30).
Selecting the frequency band (BAND)
Selects the receive frequency band.
This menu is not available on Japanese and Korean
mod
els. On these models, the frequency band cannot be
selected.
For details about the groups and channels in each
f
requency band, refer to the “Frequency List”.
Searching for and selecting available
channels (CLR CH SCAN)
Searches for available channels.
For details, see “Searching for available channels within
a group (Clear Channel Scan)” (page 28).
Setting the audio output level (OUTPUT
LEVEL)
Sets the audio output level. You can set the level in 3 dB
increments in the range –12 dB to +12 dB. The factory
d
efault setting is 0 dB.
The monitor output level does not change when you
ch
ange the output level in the OUTPUT LEVEL menu.
The monitor output level is adjusted separately.
For details about adjusting the monitor audio level, see
“Adjusting the monitor audio level” (page 30).
Configuring transmitter settings via NFC
communication (SYNC RX->TX)
Transfers the frequency and compander mode set on the
tuner to a transmitter using NFC communication.
1 Press the + or – button to display the SYNC RX->TX
menu.
2 Press and hold the SET button for one second or
longer.
A confirmation screen appears.
3 Press the + or – button to display “YES,” and press
the SET button.
4 Place the N-Marks of both the tuner and transmitter in
close proximity (approximately 5 mm).
At this time, make sure that the transmitter is turned
o
n or that the battery level is sufficient and the
transmitter is turned off.
The frequency and compander mode for use on the
tra
nsmitter are set.
• NFC communication lasts approximately 20 seconds.
P
erform step 4 w
ithin 20 seconds of performing step 3.
After 20 seconds have elapsed, NFC communication
aut
omatically finishes and the GP/CH menu appears.
• During NFC communication, the signal from a wireless
mic
rophone cannot be received.
Reflecting transmitter settings on the
tuner via NFC communication (SYNC
TX->RX)
Accesses the frequency and compander mode set on the
transmitter and reflects those settings on the tuner using
NFC communication.
1 Press the + or – button to display the SYNC TX->RX
menu.
2 Press and hold the SET button for one second or
longer.
A confirmation screen appears.
3 Press the + or – button to display “YES,” and press
the SET button.
4 Place the N-Marks of both the tuner and transmitter in
close proximity (approximately 5 mm).
At this time, make sure that the transmitter is turned
o
n or that the battery level is sufficient and the
transmitter is turned off.
Note
Note
Notes