Operating Instructions

28
3 Press the + or – button to select the desired group
name, then press the SET button.
The channel group is set, and the channel number
d
isplay starts flashing.
4 Press the + or – button to select the desired channel
number, then press the SET button.
The displays stops flashing and the desired channel is
set.
Procedure for portable diversity tuner
(URX
-P41D)
For details about the channel groups and channels that can
be
selected, refer to the “Frequency List”.
1 Press the MENU button to display the RX1 menu or
RX2 menu, then press the + or – button to display the
GP/CH screen.
2 Press and hold the SET button for one second or
longer.
The channel group display starts flashing.
3 Press the + or – button to select the desired group
name, then press the SET button.
The channel group is set, and the channel number
d
isplay starts flashing.
4 Press the + or – button to select the desired channel
number, then press the SET button.
The displays stops flashing and the desired channel is
set.
• If there is no user input within ten seconds after the
ch
annel group display or channel number display starts
flashing, the displayed setting that is flashing is saved.
The same applies when setting other parameters.
• The frequency indicator changes in response to the
chan
nel number.
• The tuner continues to receive, even when setting the
recei
ve channel.
• Do not remove the batteries while setting the receive
chan
nel. If they are removed or the power is turned off,
power the unit on again and repeat the procedure from
the beginning.
• Make sure that the same channel is set on the
tr
ansmitter and tuner within the same system.
Searching for available channels
within a group (Clear Channel Scan)
Procedure for portable diversity tuner (URX-P40)
You can search for available channels within the
speci
fied channel group.
Before performing this procedure, select the channel
gr
oup.
For details, see “Setting the receive channel” (page 27).
1 Press the + or – button to display the CLR CH SCAN
menu.
2 Press and hold the SET button for one second or
longer.
Press and hold until the channel group and “+”
di
splay starts flashing.
3 Press the + button.
The tuner starts to scan through the selected channel
grou
p. When available channels are found, the first
channel number among the available channels starts
flashing on the display.
To display the next available channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the CLR CH
SCAN menu.
4 Press the SET button when the desired channel
number starts flashing.
The search for available channels finishes and the
di
splayed channel is set.
Once a channel is confirmed, you can select whether
t
o send the setting via NFC communication.
Notes