So N _Y; 3753-737-21 (1) Active Speaker System Operating Instructions Table of Contents Ba fore operating the unit, please read this mans) thoroughly and retain it for future reference.
Owner’s Record The model and serial numbers are located at the rear. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. SRE-D2K Serial No. [WARNING | To prevent fire or shock hazard, do not expose the unit to rain or moisture. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER-SERVICEABLE PARTS INSIDE.
Location of Parts and Controls The S RS-D2 wooter/amplitier POWER lamp o oo POWER switch © control & BASS LEVEL control o — INPUT 2 (LR) (phonon fracks) BALANCE control INPUT SELECT switch RETIREE Hrt— SPEAKER terminals Wooster Front Rear Power cord Connections Before connecting speakers Be certain that the POWER switch Is set to STANDBY {POWER tamp is off).
Connections Use the connecting cords and/or the adapter (sold separately) for the connections below, To connect the monaural mini jack of the equipment o earphones jack {monaural Plug adapter PC-236MS {sod separately} To connect the phonon jack outputs of the audio equipment 1o line outputs INPUT 1 of INPUT 2 o e Connecting cord AK-C156 {sold separately} CO player, cassette-deck, idea deck, TV monitor, elc.
System Connection +To get an optimum stereo effect, take care fo do as follows: connect the right speaker to the R terminal of the woofer/ amplifier, and the left speaker to the L terminal. ~Be sure to connect the @ to the @, and the © to the & terminals, «Be careful not to short the speaker cords between ® and & terminals. Otherwise, the speaker may be damaged.
Set INPUT SELECT to select the audio equipment as described below. Audio equipment Set INPUT SELECT connected to the input of: | switch to: INPUT 1 (on the rear} Setting position 1 L1 Depress POWER (ON ). The power lamp will light up. INPUT 2 (on the rear} Setting position = Ot 4 Adjust the overall ® sound level with VOLUME. BASS LEVEL BALANCE After listening Press POWER o tum off the power (STANDBY 1), The power lamp will go out.
Installation ¥ Before Installation Use the supplied rubber cushions to: #soak up the vibration of the speakers, ~avoid scratching the surface of the shelf, and secure the speaker installation. t the Woofer You can place it anywhere in the room, because the human ear can hardly distinguish where bass sounds come from. To reinforce the bass more efficiently, place the woofer so that iris partially enclosed, as in the room comer.
Specifications AUDIO POWER SPECIFICATIONS Full-range With 4-ohm loads, both speakers channels driven from (RS-002) Hz: rated 4 W per channel! minimum RMS power, with no more than 10% total harmonic distortion in AC operation. Woofer With 4-ohm loads, driven from (S RS-D2) 40-150 Hz: rated 10W minimum RMS power, with no more than 10% total harmonic distortion in AC operation.
