Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 5: Appendix: Controller compatibility chart
64
Function compatibility for RCP/MSU to ILME-FR7, BRC-X1000/H800/X400
Operation panel Function Conditions
ND
*1
ND filter
IRIS
*2
Iris Enabled when AE is set to MANUAL on the
camera.
SHUTTER
*2 *3
Shutter speed
MASTER GAIN Gain
SCENE FILE
*1
Preset Recall, preset Set Enabled when the camera preset mode is not set
to TRACE. If the camera preset mode is set to
TRACE, movement recorded in TRACE is shown in
playback.
WHITE R
*2
R-Gain Enabled when white balance is set to MANUAL on
the camera.
WHITE B
*2
B-Gain
MASTER BLACK Black Level Offset
Detail Auto/Manual
DETAIL Detail Level
Detail Crispening
Detail H/V Balance
Matrix STD/OFF
R-G, G-B, B-R, R-B, G-R, B-G Enabled when Matrix is turned ON on the camera.
Gamma Level
Black Gamma Level
Knee Setting, Knee Point, Knee
Slope, Knee Mode
Noise Reduction Enabled when ADVANCED is not set on the
camera.
Flicker Reduction
BARS Color Bar
Update the BRC-X1000/H800 software to v2.0 or later before use.
Update the ILME-FR7 software to v1.10 or later before use.
*1 Not supported on the BRC-X400. When using the ILME-FR7, set the ND filter preset mode beforehand.
*2 SRG-360SHE supports IRIS, SHUTTER, MASTER GAIN, WHITE R/B only.
*3 The ILME-FR7 does not support SHUTTER.