Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 5: Appendix: Controller compatibility chart
61
When using a panel sheet
Control block Button/knob Function Conditions ILME-FR7
Lens control block AE button Exposure mode selection When the button is on (lit): Follows CONFIG >RM SETUP > AE ON CFG setting in the RM menu.
When the button is off (not lit): Full manual.
Yes
FOCUS adjustment knob Manual focus adjustment – Yes
AF/MF button Focus adjustment mode selection – Yes
Push AF/MF button Temporary focus adjustment mode change When the AF/MF button is on (lit): Auto focus is stopped while the button is pressed.
When the AF/MF button is off (not lit): Auto focus is active while the button is pressed.
Yes
ND FILTER/IRIS knob Iris value or ND filter value adjustment The iris value is adjusted when CONFIG >SW ASSIGN >IRIS KNOB is set to IRIS in the RM menu.
The ND filter value is adjusted when set to ND FILTER.
Yes
Color adjustment
block
WB SET button One-push white balance auto adjustment Enabled when OPERATION >WHITE >WB MODE is set to MEM.A T/T or MEM.A R/B in the RM menu. Yes
REC START/STOP button Start/stop recording When the button is off (not lit): Start recording.
When the button is on (lit): Stop recording.
Yes
BARS button Toggle color bars output on/off. – Yes
ASSIGN 1 to ASSIGN 3 buttons Toggle backlight compensation on/off. Enabled when the AE button is lit. Yes
Camera assignable buttons 1 to 9 – Yes
Lens assignable button FOCUS HOLD – Yes
Display switching – Yes
Color temperature/R-WHITE
knob and Tint/B-WHITE knob
Color temperature and tint adjustment
R gain and B gain adjustment
Color temperature and tint adjustment when OPERATION >WHITE >WB MODE is set to MEM-A T/T
or ATW in the RM menu.
R gain/B gain adjustment when set to MEM-A R/B.
Color temperature adjustment when set to PRESET. Tint cannot be adjusted.
Yes
R-BLACK knob/B-BLACK knob R black and B black adjustment Enabled on the ILME-FR7 when [Base Setting] >[Shooting Mode] is set to [Custom] in the [Project]
menu.
Yes
MASTER BLACK knob Master black adjustment – Yes
Yes: Supported
–: Not supported