Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
Chapter 3: Products: Optional items for BRC-H900
00048
Optional items for BRC-H900
BRBK-IP10
Card for LAN connection between
BRC-H900 and remote controller
Attach to BRC-H900 to connect to IP remote
controller RM-IP500, RM-IP10 via network.
HD-SDI/SD-SDI signal output is possible.
Selection of HD-SDI or SD-SDI output is
possible via a switch.
CNA-1
Camera control network adapter for
expanding a Sony camera network
system
Using this device and optional software
HZC-BRCN1 makes it possible to connect
BRC-H900 to RCP-3500/3100/1500/1501/1530.
BRBK-SF1
Optical fiber cable connection card
Use this to connect BRC-H900 to multi
interface unit BRU-SF10 via an optical fiber
cable.
BRU-SF10
Multi interface unit for optical fiber
cable connection
Connect BRC-H900 with attached optical
fiber cable connection card BRBK-SF1 to this
device using an optical fiber cable (single
mode LC-LC duplex connector) to transmit
signals over long distances.
BRBK-HSD2
HD/SD switching SDI output card
Attaching this to the BRC-H900 and multi
interface unit BRU-SF10 makes it possible
to output HD-SDI/SD-SDI signals. Selection
of HD-SDI or SD-SDI output is possible via a
switch.