Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: Connection with RCP-3500/3100/1500 series
32
Connection with RCP-3500/3100/1500 series
Devices
Remote camera with
interchangeable lens
ILME-FR7
Remote camera BRC-X1000/H800, BRC-H900, BRC-X400, SRG-360SHE
Remote control panel RCP-3500/3501/3100/1500/1501/1530
Camera control network adapter CNA-1*
Other Commercially available switching hubs, setup PC
* When using BRC-H900
What you can do
You can connect to a network camera in Bridge Mode via network connection from a Sony-brand remote
control panel. In Bridge Mode, the network camera and RCP communicate on a one-on-one basis.
For information on available functions of each camera, see “Function compatibility for RCP/MSU to ILME-
FR7, BRC-X1000/H800/X400” (page 64).
Setup instructions
This connection procedure uses the ILME-FR7, BRC-X1000/H800, RCP-3500/3100/1500 connection for
explanation purposes. See the HZC-BRCN1 operation manual for details on Bridge Mode connection
when using camera control network adapter CNA-1 and BRC-H900.
1. Connect the devices using the diagram on the left as a reference, then turn them on.
2. Set the IP address of each camera to connect to.
See “Auto IP address setting from RM-IP500” (page 19) and “IP address setting from RM-IP Setup
Tool” (page 21) for instructions on how to set IP addresses.
Continued on the following page
RCP-1500/1501RCP-3500/3501
BRC-X1000
RCP-3100
ILME-FR7
Switching hub
Remote control signal: Network cable (Cat 5e or higher)
Signal flow
Setup PC