Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: Tally control from MCX-500
29
6. Select the [TALLY MODE] from the following two options.
NORMAL
When switching MCX-500 video, the RM-IP500 controlled camera switches and the RM-IP500 camera
select block tally input lamp is lit.
ON AIR TALLY
When switching MCX-500 video, the RM-IP500 camera select block tally input lamp is lit. RM-IP500
controlled cameras are not changed.
When CAMERA LINK is turned ON, the camera tally lamp will switch in coordination with MCX-500
video selection.
Precautions
Set RM-IP500 COMMAND SEL to STANDARD.
When using MCX-500 VIDEO/HDMI video input and you select video 1 to 4, the RM-IP500 camera
number changes between 5 to 8.