Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: Tally control from MCX-500
28
Tally control from MCX-500
Devices
Remote camera BRC-X1000/H800, BRC-H900, SRG-360SHE, SRG-300SE, SRG-300H,
SRG-120DH, SRG-120DS, BRC-X400, SRG-X400, SRG-X120, SRG-XB25,
SRG-XP1
Remote controller RM-IP500, RM-IP10
Switcher MCX-500
Other Commercially available switching hubs
What you can do
You can input remote camera video to MCX-500.
You can select the remote controller camera number and switch the remote camera tally lamp
according to video switching input to MCX-500.
Setup instructions
1. Connect the devices using the diagram on the left as a reference, then turn them on.
For details on MCX-500 and remote controller tally connector pin arrangements, see “Chapter 5
Appendix” > “TALLY terminal (MCX-500)” (page 67).
2. Press the MCX-500 ASSIGN button and select the MCX-500 video input connector number you
want to use from the [VIDEO INPUT SELECT] line.
3. Select [ENABLE] from the MCX-500 screen, then select the type of input connector you want to
use.
At default settings, the video from devices connected to SDI input connectors is assigned to inputs 1
to 4.
Once assignment is complete, the video input selected in PGM output is displayed.
4. Configure the remote controller and MCX-500 tally connection.
RM-IP500 is used for this explanation.
5. Set RM menu CONFIG >GPI I/O [SETTING] to [INPUT].
Continued on the following page
RM-IP500
MCX-500
RM-IP10
or
To remote camera
HDMI video input
connector
To remote camera SDI
video input connector
Tally/contact signal: Tally connection cable*
Video signal: HDMI cable
Video signal: Connecting cable with BNC connector
Signal flow
* Refer to the connector pin array in the index for further details.