Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: Fiber connection from BRC-H900
27
Fiber connection from BRC-H900
Devices
Remote camera BRC-H900
Control card BRBK-SF1
HD Optical Multiplex Unit BRU-SF10
Remote controller RM-IP500, RM-IP10
What you can do
Image/audio signals, control signals, and external synchronization signals output from the BRC-H900 with
attached BRBK-SF1 can be transmitted over long distances via fiber optics.
Setup instructions
1. Connect the devices using the diagram on the left as a reference, then turn them on.
2. Set the camera communication system using BOTTOM switch 3 on the bottom of the camera and
the communication BAUD RATE using switch 4.
3. Change VISCA FUNCTION switch 1 (RS-232C/RS-422) and switch 2 (communication BAUD RATE)
on the back of BRU-SF10 to the same setting as the camera.
4. Set the remote controller communication system and communication BAUD RATE.
See “Serial connection setting (RS-422/RS-232C)” (page 24) for details on adjusting settings.
Precautions
The VISCA RS-232C and VISCA RS-422 connectors on the camera cannot be used during optical fiber
cable connection.
SDI OU T
MONITOR
1 2
BRBK-HSD2
ON
HD SD
OFF
AUDIO IN BRU
BRBK-SF1
LR
BRC-H900
BRBK-SF1
Optical fiber
cable connection
card
RM-IP10
BRU-SF10
HD monitor
Video signal: Optical fiber cable (Single mode LC-LC duplex connector)
Video signal: Connecting cable with BNC connector
Remote control signal: Network cable modified for terminal block connection (Cat 5e or higher)
Signal flow