Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: IP address setting from RM-IP Setup Tool
23
Precautions
BRBK-IP10 control card (sold separately) is required to control BRC-H900 via IP.
In this operation, only remote controllers and cameras in the same segment as a computer where
the RM-IP Setup Tool has been installed can be detected. For details on how to assign cameras to a
different segment, see the RM-IP Setup Tool Guide.
RM-IP Setup Tool may not operate correctly (no cameras are shown in the list even if they are
connected and configured correctly), depending on the configuration of Windows Firewall. For further
details check the RM-IP Setup Tool Guide.