Remote Camera System Guide

000
Chapter 2: Connection & Basic Settings:  IP address setting from RM-IP Setup Tool
22
3. Enable camera registration on RM-IP500 and RM-IP10.
For RM-IP500

From the RM menu, select MAINTENANCE >UPDATE MODE, and the following screen appears.

Change [UPDATE MODE] to [ON] and press the VALUE button.
* Note that a one-time password is not used when making settings from the RM-IP Setup Tool only.
For RM-IP10

Set DIP switch 1-1 on the bottom of the device (RS-422/LAN) to OFF (LAN), and change DIP
switch 2-8 (SETTING) to ENABLE, and restart RM-IP10.
After restarting the device, the control button is lit green.
4. Launch the RM-IP Setup Tool installed on the PC.
5. Set the IP address of each camera in the [Camera] tab.
6. Set each remote controller IP address in the [Controller] tab.
7. Select the [Camera Table] tab, then select the remote controller you want to set from the
[Controller] pull-down menu.
8. Click the [Camera Name] of the camera group and camera number you want to assign, then select
the camera name to assign to that number from the pull-down menu.
* When making initial settings, you can assign the camera group and camera number automatically by clicking [Auto
Assign].
Continued on the following page
