Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: IP address setting from RM-IP Setup Tool
21
IP address setting from RM-IP Setup Tool
Devices
Remote camera with
interchangeable lens
ILME-FR7
Remote camera BRC-X1000/H800, BRC-H900, BRC-X400, SRG-A40, SRG-A12, SRG-X400,
SRG-X120, SRG-X40UH, SRG-360SHE, SRG-300SE, SRG-300H, SRG-120DU,
SRG-120DH, SRG-120DS, SRG-XB25, SRG-XP1
Control card BRBK-IP10*
Remote controller RM-IP500, RM-IP10
Edge Analytics Appliance REA-C1000
Other Commercially available switching hubs, setup PC
* When using BRC-H900
What you can do
You can assign each camera to the RM-IP500 and RM-IP10 remote controller using the RM-IP Setup Tool
installed on the PC.
Setup instructions
1. Connect the devices using the diagram on the left as a reference, then turn them on.
2. Set the PC IP address, subnet mask, and default gateway.
See the PC manual for details on how to set these items.
Set the IP address to the same segment as the remote camera and remote controller.
Continued on the following page
RM-IP500
RM-IP10
ILME-FR7
BRC-X1000, BRC-H800
SRG-A40
Remote control signal: Network cable (Cat 5e or higher)
Signal flow
Switching hub
Setup PC