Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 2: Connection & Basic Settings: Auto IP address setting from RM-IP500
19
Auto IP address setting from RM-IP500
Devices
Remote camera with
interchangeable lens
ILME-FR7
Remote camera BRC-X1000/H800, BRC-H900, SRG-360SHE, BRC-X400, SRG-A40, SRG-A12,
SRG-X400, SRG-X120, SRG-X40UH, SRG-300SE, SRG-300H, SRG-120DH,
SRG-120DS, SRG-120DU, SRG-XB25, SRG-XP1
Control card BRBK-IP10*
Remote controller RM-IP500
Other Commercially available switching hubs
* When using BRC-H900
What you can do
Automatically assign the IP address and camera number of remote cameras in the same segment from
the RM-IP500 remote controller.
Setup instructions
1. Connect the devices using the diagram on the left as a reference, then turn them on.
2. Press the RM-IP500 RM MENU button, then from TOP MENU select CONFIG >LAN.
The following screen appears.
3.
Set the RM-IP500 IP address, subnet mask, and default gateway.
Continued on the following page
RM-IP500
ILME-FR7
BRC-X1000, BRC-H800
SRG-360SHE
Remote control signal: Network cable (Cat 5e or higher)
Signal flow
Switching hub