Remote Camera System Guide
Table Of Contents
- Table of Contents
- Read This First
- Chapter 1 Application
- Chapter 2 Connection & Basic Settings
- [A] Auto IP address setting from RM-IP500
- [B] IP address setting from RM-IP Setup Tool
- [C] Serial connection setting (RS-422/RS-232C)
- [D] Connection with 4K video switcher
- [E] Fiber connection from BRC-H900
- [F] Tally control from MCX-500
- [G] Connection with AWS-750
- [H] Connection with RCP-3500/3100/1500 series
- [I] Connection with MSU-1000/3000 series
- [J] NDI® | HX connection
- Chapter 3 Products
- Chapter 4 Edge Analytics Appliance Application
- Edge Analytics Appliance Application Configuration
- Usage example of Handwriting Extraction in the classroom
- Usage example of PTZ Auto Tracking in the lecture hall
- Usage example of Close-up by Gesture in the classroom
- Usage example of Chroma key-less CG Overlay in a small-scale studio
- Usage example of Focus Area Cropping at an event space
- Recommended cameras for connection with Edge Analytics Appliance
- Chapter 5 Appendix
000
Chapter 5: Appendix: Pin assignments
66
RS-232C
VISCA RS-232 IN terminal
VISCA RS-232 IN
Pin No. Function
1 DTR IN
2 DSR IN
3 TXD IN
4 GND
5 RXD IN
6 GND
7 SIRCS OUT*
8 Not used
* Pin 7 SIRCS OUT can be switched using the BOTTOM
switch.
VISCA RS-232 OUT terminal
VISCA RS-232 OUT
Pin No. Function
1 DTR OUT
2 DSR OUT
3 TXD OUT
4 GND
5 RXD OUT
6 GND
7 Not used
8 Not used
RS-422/RS-232C terminal of each camera
Camera/Remote controller RS-422 connector RS-232C connector
BRC-X1000, BRC-H800, BRC-X400, SRG-A40,
SRG-A12, SRG-X40UH, SRG-X400, SRG-X120,
SRG-360SHE, RM-IP500
RJ45 Not supported
BRC-H900, SRG-300H, RM-IP10 9-pin contact terminal block Mini DIN 8-pin type
SRG-300SE 9-pin contact terminal block Not supported
SRG-120DS, SRG-120DH, SRG-120DU, SRG-XB25 Not supported Mini DIN 8-pin type