User Manual

49
Detailed Menu Description
Chapter 5 Menu Items
SETUP Menu
ALT/[F5] A/E IN Selects whether to pass the signals input to the DIGITAL AUDIO INPUT (AES/EBU)
connector through the sampling rate converter.
Auto
: Passes the input signals through the sampling rate converter. In this case,
there are no limitations on input signals.
Vlock: Does not pass the input signals through the sampling rate converter. In this
case, the input signals need to be locked to video signals at 48 kHz. Noise will
occur if this condition is not met.
In
ALT/
[F10]
AUDIO SETTING Sets other settings. I/O
[F1] SCALE Sets the mode for displaying digital audio levels.
Peak0
: Displays minus audio levels with the maximum level set to 0 dB.
Ref0: Displays plus/minus audio levels with the reference level set to 0 dB.
I/O
[F10] EXIT Redisplays the previous menu. –
Button Indication Setting Target
[F1] USER BANK Saves or recalls menu settings. (see page 42) Unit
[F1] SYSTEM RECALL Recalls overall unit settings from the user banks. Unit
[F2] PB PORT RECALL Recalls output port settings from the user banks. Out
[F3] REC PORT
RECALL
Recalls input port settings from the user banks. In
[F4] SYSTEM SAVE Stores overall unit settings in the user banks. Unit
[F5] PB PORT SAVE Stores output port settings in the user banks. Out
[F6] REC PORT SAVE Stores input port settings in the user banks. In
[F10] EXIT Redisplays the previous menu. –
[F2] PANEL SETTING Sets the settings for panel operation. Unit
[F1] BEEP KEY Turns on or off the click sound emitted during panel operation.
On
Off
Unit
[F2] BEEP ALARM Turns on or off the alarm sound when an error occurs.
On
Off
Unit
[F3] REF ALRM Sets whether to display a warning when the video/audio reference signal selected in
REF SEL is not present or not in sync with the video input signal.
On
Off
Unit
[F7] DISPLAY SETTING Sets the settings for the display. Unit
[F1] DIMMER Adjusts the brightness of the display backlight.
1 to 3
to 5
Unit
[F3] WARN Sets whether to popup warning messages.
Off
On
Unit
[F6] RESIDUAL Sets what to display in the remaining amount indication for the SRMemory card.
Time: Displays the remaining recording time.
Capacity: Displays the remaining amount of memory.
Ratio: Displays the remaining amount as a ratio.
Unit
[F10] EXIT Redisplays the previous menu. –
[F10] EXIT Redisplays the previous menu. –
Button Indication Setting Target