User Manual

47
Detailed Menu Description
Chapter 5 Menu Items
ALT/[F8] MONITOR
SETTING
Sets the settings for monitor output in 3D mode. Out
[F1] DUAL Sets the monitor output for 3D mode.
Link-AB
: Outputs each of the LINK-A signal (the signal input from the HD SDI
INPUT A connector) and LINK-B signal (the signal input from the HD SDI
INPUT B connector) in the same way as with main output.
Link-BA: Outputs with LINK-A and LINK-B interchanged in relation to the main
output.
Note
When this item is set to any of the following, the same signal is output for LINK A
output and LINK B output.
Link-A: Outputs the LINK-A signal.
Link-B: Outputs the LINK-B signal.
Splt-AB: Splits the screen into two and outputs the LINK-A signal to the left screen
and the LINK-B signal to the right screen.
Splt-BA: Splits the screen into two and outputs the LINK-B signal to the left screen
and the LINK-A signal to the right screen.
FSq-AB: Outputs the LINK-A signal to the 1st field and the LINK-B signal to the 2nd
field.
FSq-BA: Outputs the LINK-B signal to the 1st field and the LINK-A signal to the 2nd
field.
SxS-AB: Splits the screen into two and then reduces the width of the LINK-A signal
by half and outputs it to left screen and reduces the width of the LINK-B signal
by half and outputs it to the right half.
SxS-BA: Splits the screen into two and then reduces the width of the LINK-B signal
by half and outputs it to left screen and reduces the width of the LINK-A signal
by half and outputs it to the right half.
Out
[F2] BORDER Selects whether to display a dividing line on the screen when the unit is set to split
the screen into two and output the signals to the monitor during 3D mode.
Off
On
Out
[F3] BD LEVEL Sets the brightness level of the dividing line on the screen when the unit is set to
split the screen into two and output the signals to the monitor during 3D mode.
1 to 8
to 127
Out
[F4] BD SLOPE Selects whether the dividing line is sloped on the screen when the unit is set to split
the screen into two and output the signals to the monitor during 3D mode.
Off
On
Out
[F5] BD POS Sets the position of the dividing line on the screen when the unit is set to split the
screen into two and output the signals to the monitor during 3D mode.
–480 to 0
to 480
Out
[F10] EXIT Redisplays the previous menu. –
ALT/
[F10]
PORT CONFIG Sets the input/output signals of the input/output ports. I/O
[F2] SCAN Sets the scanning method.
Interlace
PsF
Progres
I/O
[F3] SIZE Sets the resolution.
1280 : 720
1920 : 1080
I/O
[F4] SIGNAL Sets the sampling rate of video signals.
YPbPr
RGB
I/O
[F5] 2D/3D Sets 2D/3D operation.
2D
3D
I/O
Button Indication Setting Target