Modification of Sony ICF-SW77 for DRM Software receiver Date: 19-11-02 Page 1 of 8
Table of Contents 1 INTRODUCTION ......................................................................................................................................... 3 1.1 1.2 PURPOSE OF THIS DOCUMENT ................................................................................................................... 3 ORGANIZATION OF THIS DOCUMENT ........................................................................................................ 3 2 SYSTEM OVERVIEW..............................
1 Introduction 1.1 Purpose of this document This document describes how to modify a Sony ICF-SW77 short wave receiver to be able to receive a DRM signal. Therefore the DRM – Miniature Mixer Unit from Sat-Service Schneider is used, to mix down the 455 kHz IF of the receiver to a 12 kHz IF. This 12 kHz IF is feed to a PC sound card. Please note that the manufacturer's warranty will be discarded if you do this modification. 1.2 Organization of this document Chapter 1 provides an introduction to the document.
wide band filter narrow band filter ZF in GND The IF section has two IF filters, a narrow band filter and a wide band filter. One of these filters has to be replaced by a wider filter with appr. 10 kHz bandwidth. The filter ‘W’ is active if the receiver is in ‘wide’ mode, the filter ‘N’ is active if the receiver is in ‘narrow’ mode.
3.2 Filter bandwidth The with the receiver supplied wide band IF filter has a bandwidth ob appr. +/- 3 kHz. The bandwidth is shown in following diagram: The recommended replacement filter is a Murata CFWM455GY, which has the same footprint as the original filter, but a bandwidth of appr. +/- 4,5 kHz.
3.3 IF Filter types The following Murata filter types are fitting into the IF filter footprint in the SW77 receiver: Part Number 6 dB bandwidth CFWM455G +/- 4.5 kHz CFWM455F +/- 6.0 kHz CFWM455E +/- 7.5 kHz 4 Connection of DRM Miniature Mixer Unit The IF frequency is 455 kHz in the SW77 receiver. Therefore the mixer unit with a 467,0 kHz oscillator is needed. It is recommended to use the mixer unit with the crystal oscillator.
4.1 Power supply The mixer unit needs a power supply with 7-20 V DC. Unfortunately the receiver supplies a maximum voltage of 6 V. Test showed that it is possible to use the 6V instead of the 7-20 V to run the mixer unit. An other possibility is to remove the voltage regulator on the mixer unit and replace it with a diode (e.g. 1N4007). The 6V power lines of the mixer unit can be connected to the connector at the right side of the PCB (back view). The +6V line is the most top solder point.
Date: 19-11-02 Page 8 of 8
