User Guide

8
2 Using the supplied HD15-HD15 video signal cable
(analog RGB), connect the computer to the
monitor’s HD 15 input connector (analog RGB) for
INPUT 1 or INPUT2.
Connect the computer according to the following
illustrations.
xConnecting to an IBM PC/AT or
compatible computer
xConnecting to a Macintosh
When connecting a Macintosh computer, use an adapter (not supplied),
if necessary. Connect the adapter to the computer before connecting the
video signal cable.
Setup 3:Connect the audio cord
Connect the supplied audio cord to the monitor’s
corresponding audio input jack.
Using the monitor’s speakers or headphones, you can listen to
sound from your computer or other audio equipment connected to
the monitor’s audio input jacks.
For more information, see “Controlling the volume” on page 18.
Setup 4:Connect the power cord
1 Connect the supplied power cord to the monitor’s
AC IN connector.
2 Connect it to a power outlet.
IBM PC/AT or
compatible computer
to the HD 15 input
connector (analog RGB)
for INPUT1 or INPUT2
to the computer’s HD15 output
connector (analog RGB)
HD15-HD15 video signal
cable (analog RGB)
(supplied)
Macintosh
HD15-HD15 video signal
cable (analog RGB)
(supplied)
to the computer’s output
connector
to the HD 15 input
connector (analog RGB)
for INPUT1 or INPUT2
to the audio input for
INPUT1 or INPUT2
to audio output of the
computer or other
audio equipment
audio cord (supplied)
2
power cord (supplied)
to power outlet
1
to AC IN