Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
48
Notes
• Positions of camera ports vary by camera.
• If you adjust the tilt axis of the gimbal, the hot shoe cable and USB cable may come into contact with the
frame of the gimbal. Route the cables so that they do not come into contact with the gimbal frame.
• Before removing the camera from the gimbal, disconnect the hot shoe cable or pull out the pin jack. Be
careful not to pull out the flash sync relay cable from the gimbal.
[5] Adjusting the balance of the gimbal
Notes
• Be careful not to get your fingers caught in the tilt frame, roll frame, or pan frame when adjusting the balance
of the gimbal.
• When using the RTK kit, confirm that the camera and gimbal are connected using the hot shoe cable and
flash sync relay cable before starting to adjust the balance of the gimbal (page 47).
1 Refer to the Startup Guide included with the ARS-S1 and follow the
steps below.
“Gimbal and camera mounting” chapter
• “[4] Adjusting the balance of the gimbal” under “Mounting a camera on the gimbal”
Under step 1, perform in “Horizontal balance adjustment of the tilt axis.”
2 Confirm that the hot shoe cable is not disconnected from the camera's
shoe terminal.
3 Refer to the Startup Guide included with the ARS-S1 and follow the
steps below.
“Gimbal and camera mounting” chapter
• “[4] Adjusting the balance of the gimbal” under “Mounting a camera on the gimbal”
Perform all the operations that follow in "Horizontal balance adjustment of the tilt axis"
under step 1 to adjust the balance of the tilt, roll, and pan axes.
[6] Adjusting the gimbal parameters
The gimbal parameters need to be adjusted.
Visit the support site for details on adjustment.
http://electronics.sony.com/airpeak/p/gblt3/settings