Instruction Manual

12
GB
PS-LX300USB.GB.3-198-123-15(2)
Setting up your computer:
Windows 7
([Control Panel] is in the [Category] view)
1 Select [Control Panel] from the [Start]
menu.
2 Click [Hardware and sound].
3 Click [Manage audio devices] in
[Sound].
4 Click the [Recording] tab, and check if
[Default device] is set for [USB Audio
CODEC].
5 Select [USB Audio CODEC], and then
click [Properties].
6 Click the [Advanced] tab.
7 Select [2 channel, …] (ex: [2 channel,
16 bit, 44100 Hz (CD Quality)] or
[2 channel, 16 bit, 48000 Hz (DVD
Quality)]) from the [Default Format]
drop-down list.
8 Click [OK].
Note
To input a stereo signal from the turntable to the
computer, steps 5 through 8 are necessary.
To set the signal input level
1 Click the [Levels] tab in the [USB Audio
CODEC] property screen.
2 Move the slider to 0.
3 Adjust the slider using the cursor key.
e appropriate setting for the turntable is 2
in the [0, 0, 1, 2, 3, …] level display.
Check that the mute button is not active at
this time.
Level display
Slider
Mute button
4 Click [OK].
Note
Do not exceed the recommended setting range when
setting the input level (such as setting the le side all the
way to 0 or increasing the numerical value of the level
display). Doing so may cause the sound not to be output
or to be distorted.