Instruction Manual

11
GB
Operations
PS-LX300USB.GB.3-198-123-15(1)
Continued

Notes

e turntable is not guaranteed to operate with a USB
hub or USB extension cable. Use the supplied USB
cable.

Connect the USB cable into the USB jack/USB port
securely, or may cause a malfunction.

Disconnect the USB cable when it is not in use , or it
may cause noise.

When the turntable and computer are connected via
USB cable, the audio that is adjusted with the turntable
equalizer is input to the USB port of the computer,
when playing the turntable to record audio tracks on
your computer.
Tip
USB drivers are included in operating systems if you are
using Windows XP, Windows Vista or Windows 7. USB
drivers will be installed automatically when the system is
connected to the computer for the rst time. For details,
refer to the manual of your computer.
Setting up your computer:
Windows XP
([Control Panel] is in [Category View])
1 Select [Control Panel] from the [Start]
menu.
2 Click [Sounds, Speech, and Audio
Devices].
3 Click [Sounds and Audio Devices].
4 Click the [Audio] tab.
5 Select [USB Audio CODEC] for
[Default device:] of [Sound
recording].
6 Click [OK].
Setting up your computer:
Windows Vista
([Control Panel] is in the [Control Panel Home] view)
1 Select [Control Panel] from the [Start]
menu.
2 Click [Hardware and Sound].
3 Click [Sound].
4 Click the [Recording] tab.
5 Select [USB Audio CODEC] for
[Microphone].
6 Click [Set default].
7 Select [USB Audio CODEC], then click
[Properties].
8 Click the [Advanced] tab.
9 Select [2 channel, ...] (ex: [2 channel,
16 bit, 44100 Hz (CD Quality)]) from
the [Default Format] drop-down list.
10 Click [OK].
Note

To input stereo signal from the turntable to the
computer, performing steps 7 through 10 is necessary.

You can set the signal input level for Windows Vista SP1
or higher. For details, refer to your computer’s operating
instructions.