User Manual

81
Setup Menu
Chapter 7 Menus
Menu items in the 600s, relating to the timecode and metadata
Item number Item name Settings
601 VITC POSITION
SEL-1
a)
In 59.94i/59.94P/
29.97P mode
Select the line into which to insert VITC signals (SD output)
12H to 16H to 20H: Any line from line 12 through line 20.
Notes
• You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
• In 59.94i/59.94P/29.97P mode (J), output of wide picture information is
given priority if OUTPUT in setup menu item 731 is set to “auto” and the
VITC insertion line is set to line 16.
• In 59.94i/59.94P/29.97P mode (UC), output of wide picture information
is given priority if OUTPUT in setup menu item 731 is set to “auto” and
the VITC insertion line is set to line 20.
In 50i/50P/25P
mode
Select the line into which to insert VITC signals (SD output)
9H to 19H
to 22H: Any line from line 9 through line 22.
Note
You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
602 VITC POSITION
SEL-2
a)
In 59.94i/59.94P/
29.97P mode
Select the line into which to insert VITC signals (SD output)
12H to 18H
to 20H: Any line from line 12 through line 20.
Notes
• You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
• In 59.94i/59.94P/29.97P mode (J), output of wide picture information is
given priority if OUTPUT in setup menu item 731 is set to “auto” and the
VITC insertion line is set to line 16.
• In 59.94i/59.94P/29.97P mode (UC), output of wide picture information
is given priority if OUTPUT in setup menu item 731 is set to “auto” and
the VITC insertion line is set to line 20.
In 50i/50P/25P
mode
Select the line into which to insert VITC signals (SD output)
9H to 21H
to 22H: Any line from line 9 through line 22.
Note
You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
605 TCG REGEN MODE Select the signal to be regenerated when the timecode generator is in the
regeneration mode.
TC&UB
: Both the timecode and user bits are regenerated.
TC: Only the timecode is regenerated.
UB: Only the user bits are regenerated.
607 U-BIT BINARY GROUP FLAG Select the user bits to be used in the timecode generated by the
timecode generator.
000:not specified [000]
: Character set not specified.
001:iso character [001]: 8-bit characters compliant with ISO 646 and
ISO 2022.
010:unassigned-1 [010]: Undefined.
011:unassigned-2 [011]: Undefined.
100:unassigned-3 [100]: Undefined.
101:page / line [101]: SMPTE-262M page/line multiplex system.
110:unassigned-4 [110]: Undefined.
111:unassigned-5 [111]: Undefined.
618 UPCONV EMBEDDED VITC
a)
Select the source of the VITC embedded into output HDSDI signal when
up-converting during playback of an SD clip.
VITC
: Select the VITC of the SD clip.
LTC : Select the LTC of the SD clip.