User Manual

50
Copying
Chapter 4 Recording, Playback and Copy
4 Press the PUSH SET knob while holding down the
b/OUT button.
An IN/OUT setting window appears in the bottom
right corner of the display.
The OUT point timecode and the duration (DUR) are
displayed in the IN/OUT setting window, and the OUT
indicator lights.
5 Carry out step 4 and following of the procedure for
“Copying clips” (page 48).
To check the clip with IN and OUT points set
1 Press the B/IN or b/OUT button.
An IN/OUT setting window appears in the lower right
of the display.
2 Press the NEXT or PREV button.
The unit cues up the frame with the IN (or OUT) point
set.
To delete the IN/OUT points
1 Press the B/IN button (or b/OUT button).
The IN/OUT setting window appears in the bottom
right corner of the display.
2 Press the RESET button.
The IN (or OUT) indicator turns off.
One of the following operations deletes the IN/OUT points
automatically.
• Change the selection of media.
• Remove the media.
• Delete the clip in which IN/OUT points are set.
• Format the media.
Note