Specifications

Operation Warnings
268
Chapter 9 Maintenance
Alarm messages during thumbnail
search, scene selection, and clip list
operations
An alarm message may appear in the LCD
monitor during thumbnail search, scene selection,
and clip list operations. In that case, take the
action indicated in the following table.
SUB Clip NG The In and Out point positions are
invalid. Set correct In and Out
points.
MAX# SB
CLP
The total number of sub clips is
over the upper limit (300).
Resolution An attempt was made to register a
clip in a clip list with a different
resolution.
CL OVER
DUR
The total duration of sub clips in
the current clip list is over the
upper limit (24 hours).
FAN Stopped
DR-FAN Stop
The main unit or drive fan has
stopped. Avoid use under high
temperatures, turn off the power,
and contact a Sony service
representative.
NVRAM NG! An error was detected while
accessing internal memory. Power
the unit off and contact a Sony
service representative.
Update Err! A firmware update failed. Power
the unit off and contact a Sony
service representative.
Unknown
USB
An unsupported USB device was
connected to this unit.
NO USB
MEMORY!
A USB flash drive write operation
was attempted with no USB flash
drive connected.
USB
MEMORY
INHIBIT!
USB M. INHI
A write inhibited USB flash drive
was connected with MEMORY
REC on the MEMORY REC page
of the OPERATION menu set to
ENABL.
USB
MEMORY
ERROR!
The connected USB flash drive
was not usable when a USB flash
drive write operation was
attempted.
M. Shortage A USB flash drive write operation
was attempted without enough
free memory in the USB flash
drive.
USB
MEMORY
FULL!
A USB flash drive write operation
was attempted without free
memory in the USB flash drive.
MEM REC
NG!
A USB flash drive write operation
failed with MEMORY REC on the
MEMORY REC page of the
OPERATION menu set to
ENABL.
M. access! An attempt was made to switch
GUI screens during a USB flash
drive write operation.
Cannot
Expand Clip
any Further.
The clip cannot be expanded into
more blocks. This alarm appears
when the DISP SEL/EXPAND
button is pressed when the number
of blocks is maximum, or when
the duration of an expanded
thumbnail is one frame.
Selected
Essence Mark
Does not
Exist.
The selected essence mark does
not exist.
This alarm appears in the essence
mark selection screen when the
specified essence mark does not
exist on the disc.
Sub Clip is
Invalid. Set
Appropriate
IN/OUT
Points.
The temporal relationship between
the specified In and Out points in a
TRIM operation (see page 135) is
not correct. Reset so that the value
of the Out point timecode is larger
than the value of the In point
timecode.
Duration of
One Clip List
must be Less
than 24
Hours.
The total duration of the current
clip list exceeds the upper limit of
24 hours as the result of an Add
Sub Clips (see page 133) or Trim
Sub Clip (see page 135) operation.
No More Sub
Clips can be
Added to the
Clip List.
The total number of the sub clips
of the current clip list exceeds the
upper limit of 300 as the result of
an Add Sub Clips (see page 133)
or Trim Sub Clip (see page 135)
operation.
Sub Clip does
not Exist.
An attempt is made to execute a
Move Sub Clips (see page 135),
Trim Sub Clip (see page 135),
Delete Sub Clips (see page 136),
or Set Start Time Code (see
page 136) operation with no sub
clips in the current clip list.