Operating Instructions

Disconnecting the camera

Notes

• If you disconnect the camera while the computer is on, follow the steps below. If you

do not follow these steps the computer may malfunction.

• When your computer is off, you do not need to perform step 1 below. However, if you

disconnect the USB cable while your computer is in power-saving mode, and then

connect it again, the camera may not be detected.

1 Close the software used by the camera.

2 Disconnect the USB cable, and then remove the camera.

Notes

• If you pull on the cable itself when disconnecting the USB cable, you may damage

the cable. Make sure that you hold onto the connector when disconnecting the

cable.

• When removing the camera from the mounting adapter, spread the arm plate with

your hand, and then remove the camera.