User Guide

Bluetooth

Module UGPZ specification rev 1.1.8 March 28 /2003

ALPS PROPRIETARY INFORMATION CONFIDENTIAL REQUESTED

page3

4.1.3 Requirements to end product

The following provisions for end product will be required on the FCC regulation, part 15.

(1) Antenna

ALPS wishes that our customer shall use the UGPZ module without any modifications including

antenna. If customer use a unique antenna, the FCC certification is required for the end product.

(2) Markings

To satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the

end product.

1) UGPZ1

2) UGPZ2

3)UGPZ3

Any similar wording that expresses the same meaning may be used.

(3) Caution to user for modification

The following caution is expressed on the user’s instruction manual.

(4) Compliance statement to FCC

The following statement is expressed on the user’s instruction manual.

4.2 Canada

In general, I.C (Industry Canada) follows the FCC in terms of emission levels and other regulatory

requirements.

4.2.1 Compliance statement for IC

This device complies with Industry Canada RSS-210. Operation is subject to the following conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

4.2.2 RF exposure compliance

(1) This module may be installed into any end product both portable and mobile applications, because the

module only radiates very low power level.

(2) The installer of this device must ensure that the antenna is located or pointed such that it does not

emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6,

obtainable from Health Canada’s website www.hc-sc.gc.ca/rpb.

4.2.3 Meaning of certification number

The meaning of the marking of “IC:1788F-UGPZ#” on the UGPZ module means: “1788F-UGPZ#” is the

certification number, and the term “IC’ before the equipment certification number only signifies that

Industry Canada technical specifications were met.

Contains Transmitter Module FCC ID: CWTUGPZ1

Contains Transmitter Module FCC ID: CWTUGPZ2

Contains Transmitter Module FCC ID: CWTUGPZ3

The changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the device.

This module complies with part 15 of the FCC rules. Operation is subject to the

following conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.