User Guide

40
zRecording –
Advanced operations
Recording with a
microphone
See the illustrations in the Japanese
text (pages 12 to 14).
1 Connect the stereo microphone
(supplied) to the MIC jack.
2 Slide EJECT upward, and insert a
tape with the side to start
recording on facing cassette
holder.
Slide in the tape with the tape
shield first, and insert it until it
clicks.
3 Slide DIR MODE to select
recording on one side or on both
sides of the tape.
One side: set to A.
Both sides: set to a.
4 While pressing the red button on
REC, slide REC in the direction of
the arrow. Recording starts.
To stop recording
Press p.
To suspend recording
Press P.
To resume recording, press P again.
To adjust the sensitivity of the
microphone
While monitoring with the headphones,
set MIC SENS to H (high) or L (low)
according to the recording condition.
To record a remote or quiet sound: Set to
H
To record a close or loud sound: Set to L
To prevent accidental erasure
After recording, push the red tab on the
side of the tape you want to protect using
a pointed object. If you try to record with
the tab pushed down, "REC PROTECT"
flashes in the display and the recorder
shuts off automatically.
To record over the previous recording,
push the white tab on the opposite side
of the cassette with a pointed object.
To mix sound from two audio
sources
Connect the microphone to the MIC jack
and connect another piece of audio
equipment to the LINE IN jack of the
recorder. You can record the sound from
both sources mixed together. In this case
you cannot adjust the sound balance.
Adjusting the recording
level
Sound levels of the source are
automatically adjusted when recorded
on the tape. You can select the
automatic adjustment mode according
to the sound source. If you want to
control the recording level more
precisely, you can adjust the level
manually.
Selecting the automatic
adjustment mode
See the illustrations in the Japanese
text (pags 15).