MiniDisc Deck Operating Instructions

50
GB
Specifications
Additional Information
Specifications
Inputs
No Program!
You tried to start Program Play when
no program exists.
Premastered
An attempt was made to record to a
premastered MD.
ProgramFull
The program contains the maximum
number of tracks. You cannot add any
more tracks.
REMOTE
The MD is being controlled by an
external device connected to the deck.
1)
S.F Edit!
You attempted to perform another
operation while in S.F Edit (changing
the recording level after recording,
Fade-in, Fade-out) mode.
You cannot perform any other
operations while in S.F Edit mode.
Smart Space
The Smart Space Function is on
(page 19).
TOC Reading
The deck is checking the TOC (Table
Of Contents) on the MD.
1) If “REMOTE” appears under other circumstances, turn off
the deck, then turn it on again.
Message Meaning
System MiniDisc digital audio system
Disc MiniDisc
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Laser output MAX 44.6 µW
1)
1) This output is the value
measured at a distance of
200 mm from the objective lens
surface on the Optical Pick-up
Block with 7 mm aperture.
Laser diode Material: GaAlAs
Revolutions (CLV) 400 rpm to 900 rpm
Error correction ACIRC (Advanced Cross Interleave
Reed Solomon Code)
Sampling frequency 44.1 kHz
Coding ATRAC (Adaptive TRansform
Acoustic Coding)/ATRAC 3
Modulation system EFM (Eight-to-Fourteen
Modulation)
Number of channels 2 stereo channels
Frequency response 5 to 20,000 Hz ±0.3 dB
Signal-to-noise ratio Over 100 dB during play
Wow and flutter Below measurable limit
ANALOG IN Jack type: phono
Impedance: 47 kilohms
Rated input: 500 mVrms
Minimum input: 125 mVrms
DIGITAL IN OPT1 Connector type: square optical
Impedance: 660 nm (optical wave
length)
DIGITAL IN OPT2 Connector type: square optical
Impedance: 660 nm (optical wave
length)
DIGITAL IN COAXIAL Jack type: phono
Impedance: 75 ohms
Rated input: 0.5 Vp-p, ±20 %