MiniDisc Deck Operating Instructions
Table Of Contents
- WARNING
- Welcome!
- About this manual
- Table of Contents
- Location and Function of Controls
- Getting Started
- Recording to MDs
- Playing MDs
- Editing Recorded MDs
- Other Functions
- Additional Information
- AVERTISSEMENT
- Bienvenue !
- Notes sur le mode d’emploi
- Table des matières
- Emplacement et fonction des commandes
- Préparation
- Enregistrement sur un MD
- Enregistrement sur un MD
- Remarques sur l’enregistrement
- Enregistrements longue durée
- Réglage du niveau d’enregistrement
- Conseils pour l’enregistrement
- Inscription des numéros de plage à l’enregistrement
- Commencement de l’enregistrement par six secondes de son préalablement mémorisées
- Enregistrement synchronisé avec l’appareil audio de votre choix
- Enregistrement synchronisé avec un lecteur CD Sony
- Lecture de MD
- Montage de MD enregistrés
- Autres fonctions
- Informations complémentaires

43
GB
Switching the bit length/Playing with different tones
Other Functions
Switching the bit length
You can improve the output sound quality by switching
the bit length to match the MD deck, DAT deck or other
digital components connected to the digital output
connector.
1
While the deck is stopped, press MENU/NO twice.
“Setup Menu” appears in the display.
2
Turn AMS (or press ./> repeatedly) until
“Dout” appears, then press AMS or YES.
3
Turn AMS (or press ./> repeatedly) until the
desired bit length appears, then press AMS or YES.
You can select the desired bit length from 24 (factory
setting) or 16 bits.
4
Press MENU/NO.
Notes
•
This function operates only for the digital signal output
through the digital output connector.
•
If you switch the bit length during playing, the sound drops out
momentarily.
Playing with different
tones
(Digital Filter)
This deck is equipped with the V.C. (Variable Coefficient)
filters to allow you to adjust the tone to match your audio
system, listening environment, and the source being
played. Note that the digital filters are effective only on
the analog signals output from the ANALOG OUT jacks
and the PHONES jack.
1
Press FILTER.
The currently selected filter appears in the display.
2
Press FILTER repeatedly to select the filter you
want.
The FILTER button lights green when a setting other than
“FILTER-STD” is selected in DF (digital filter) display.
z
You can use the remote to select the filter
Press FILTER repeatedly until the filter you want appears in the
display.
z
What is a V.C. (Variable Coefficient) filter?
A variable coefficient filter changes the sound characteristics of
a signal by applying specific frequency cut-off conditions. Such
filters are provided on digital devices such as CD players and
MD decks to remove aliasing noise.
Note
The change in sound characteristics caused by digital filters
occur mainly in the inaudible range, not the audible range as in
the case of an amplifier.
AMSMENU/NO YES
Select To produce
FILTER-STD (factory
setting)
An expansive sound of wide
range.
FILTER 1
A sound that is clearly
positioned and smooth.
FILTER 2 A fresh and powerful sound.
FILTER 3
A resonant and mellow
sound.
FILTER
Z










