MiniDisc Deck Operating Instructions
Table Of Contents
- WARNING
- Welcome!
- About this manual
- Table of Contents
- Location and Function of Controls
- Getting Started
- Recording to MDs
- Playing MDs
- Editing Recorded MDs
- Other Functions
- Additional Information
- AVERTISSEMENT
- Bienvenue !
- Notes sur le mode d’emploi
- Table des matières
- Emplacement et fonction des commandes
- Préparation
- Enregistrement sur un MD
- Enregistrement sur un MD
- Remarques sur l’enregistrement
- Enregistrements longue durée
- Réglage du niveau d’enregistrement
- Conseils pour l’enregistrement
- Inscription des numéros de plage à l’enregistrement
- Commencement de l’enregistrement par six secondes de son préalablement mémorisées
- Enregistrement synchronisé avec l’appareil audio de votre choix
- Enregistrement synchronisé avec un lecteur CD Sony
- Lecture de MD
- Montage de MD enregistrés
- Autres fonctions
- Informations complémentaires
17
GB
Recording for long times/Adjusting the recording level
Recording to MDs
• If “LPstamp On” is set, “LP:” is recorded as part of the track
name, so the number of characters that can be input in a single
MD is reduced. Furthermore, “LP:” is automatically copied if
the track name is copied or if the track is divided by using the
Divide function.
• MDs recorded in MD LP (LP2 or LP4 Stereo) mode should be
played back on a deck that supports MD LP mode. These MDs
cannot be played back on other decks.
• If you switch REC MODE during recording or recording
pause, recording stops.
• Even if you set REC MODE to MONO, the monitor signal
during recording does not become monaural.
Adjusting the recording
level
You can adjust the recording level for both analog and
digital recordings.
You do not normally need to adjust the digital recording
level. The level is adjusted mainly when the level of the
source is low.
1
Do steps 1 to 6 of “Recording to an MD” on
page 14.
2
Play the portion of the program source with the
strongest output.
3
Press DISPLAY/CHAR (or DISPLAY) repeatedly
until the level of the input signal appears.
4
While monitoring the sound, turn DIGITAL REC
LEVEL (or press DIGITAL REC LEVEL/ANALOG
OUT LEVEL +/– repeatedly) to raise the recording
level to its highest level without turning on the two
rightmost indicators on the peak level meters.
5
Stop playing the program source.
6
To start recording, continue from step 8 of
“Recording to an MD” on page 14.
z
You can use the Peak Hold Function
The function freezes the peak level meters at the highest level
reached by the input signal.
1 While the deck is stopped or playing, press MENU/NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) until “P.Hold Off”
(factory setting) appears, then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select
“P.Hold On”, then press AMS or YES.
4 Press MENU/NO.
Adjusting the digital recording level
DIGITAL REC LEVELDISPLAY/CHAR
ANALOG REC LEVEL L/R
Avoid turning on these indicators