MiniDisc Deck Operating Instructions

15
GB
Recording to an MD
Recording to MDs
8 Press N or X.
Recording starts.
9 Start playing the program source.
Operations you may want to do during
recording
To change the display while recording
Press DISPLAY/CHAR (or DISPLAY) repeatedly to
change the display.
Each press of the button changes the display as follows:
Track number and recorded time of the current
track
r
Level of the input signal
1)
r
Sampling frequency indication
“FS -- kHz” appears while the analog signal is input.
r
DF (digital filter) display
1) “Analog In” appears while the analog signal is input.
When you pause recording
The track number increases by one. For example, if you
paused recording while recording track 4, the track
number will be 5 when you resume recording.
To prevent accidental erasure of the recorded
material
To protect an MD recording, slide the record-protect tab in
the direction of the arrow (see illustration below) to open
the slot. To enable re-recording, close the slot.
z
You can play the tracks you have just recorded
Press
N
immediately after stopping recording.
The deck starts to play from the first track of the material just
recorded.
z
You can play from the first track of the MD after
recording
1
Press
x
again after stopping recording.
2
Press
N
.
The deck starts to play from the first track of the MD.
Note
You cannot record over existing material when Shuffle Play
(page 27) or Program Play (page 27) has been selected.
“Impossible” appears in the display at this time.
To Press
Stop recording
x
Pause recording
X
Resume recording after
pausing
N
or
X
Eject the MD
OPEN/CLOSE
A
after
stopping recording
Record-protect tab
Slide in the direction
of arrow