Operating Instructions

00025
Chapter 2: Preparation
Assigning Inputs
To switch videos and mix audio, the signals from the devices connected to the input connectors on the
rear of the unit must be assigned to inputs 1 to 4.
Under default conditions, the signals are assigned as follows.
9 INPUT TERMINALS
VIDEO
SDI
VIDEO
SDI
HDMI
SDI
HDMI
SDI
TITLE
INPUT
TALLY
MULTI VIEWER PGM LINE
OUTPUT
Audio included in SDI and HDMI videos
(embedded audio) will automatically
be assigned to the audio inputs of the
same number.
Audio from the LINE input connectors is assigned.
Change the signals assigned to inputs
1 to 4 via the touch panel.
[Tips]
You can turn off (disable) automatically assigned audio. For details, see “Linking embedded audio to its video” (page 28).
Default conditions
Video input
(VIDEO INPUT
SELECT)
Audio input
(AUDIO ACCESS)
Connector
number
Input signal Status
(ENABLE/
DISABLE)
1 1 1 SDI ENABLE
2 2 2 SDI ENABLE
3 3 3 SDI ENABLE
4 4 4 SDI ENABLE
INT – – BLACK ENABLE
– LINE LINE LINE input audio signals ENABLE
Assigning Video Inputs
Under default conditions, videos from the devices connected to the SDI input connectors are assigned to
inputs 1 to 4. When devices are connected to the VIDEO and HDMI input connectors, you must change
the assigned connectors (materials).
1 Check the video inputs in the multi-viewer.
Check that videos from the connected devices appear in the [INPUT] viewer.
Display example: When SDI is assigned to inputs 1 to 4 (default)
[INPUT] viewer
"No Signal" is
displayed when
there is no signal
input.
If you want to assign different materials, proceed to step 2.