documents.type.
Table Of Contents
- Introducing the Sony Projection TV
- Installing and Connecting the Projection TV
- Contents
- Inserting Batteries into the Remote Control
- Carrying Your Projection TV
- Installing the Projection TV
- Connector Types
- Projection TV Controls and Connectors
- Basic Connections (Connecting Cable TV or Antenna)
- Connecting a VCR and Cable
- Connecting a VCR and Cable Box
- Connecting Two VCRs for Tape Editing
- Connecting a Satellite Receiver
- Connecting a Satellite Receiver with a VCR
- Connecting an Audio Receiver
- Connecting a DVD Player with Component Video Connectors
- Connecting a DVD Player with A/V Connectors
- Connecting a Digital TV Receiver
- Connecting a Camcorder
- Connecting an AV Receiver
- Using the CONTROL S Feature
- Setting Up the Projection TV Automatically
- Adjusting the Convergence Automatically – FLASH FOCUS™ –
- Adjusting the Convergence Manually
- Using the Features
- Using the Menus
- Other Information
Installing and Connecting the Projection TV
22
Model name1[KP-46WT510] Model name2[KP-51WS510] Model name3[KP-57WS510] Model name4[KP-65WS510]
[4-094-605-12]
Connecting Two VCRs for Tape Editing
If you connect two VCRs, you can record from one VCR to the other while
using your projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1 Using AUDIO and VIDEO cables, connect the playback VCR’s AUDIO
and VIDEO OUT jacks to the recording VCR’s Audio and Video IN
jacks.
2 Using AUDIO and VIDEO cables, connect the recording VCR’s
AUDIO and Video OUT jacks to the projection TV’s AUDIO and
VIDEO IN jacks.
Rear of projection TV
VCR (playback)
VCR (recording)
VMC-810S/820S (not supplied)
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
✍ To perform tape editing, set the projection TV to the video input intended
for playback by pressing TV/VIDEO on the remote control.
✍ You may need to change the video input on your VCR. Consult your
VCR’s operating manual for instructions.
✍ If both VCRs have an S VIDEO jack, you can use the S VIDEO connection
instead of the yellow video cable on a combined A/V cable.
To use an S VIDEO cable, connect the VIDEO OUT jack of the playback
VCR to the VIDEO IN jack of the recording VCR. Since S VIDEO does not
provide audio, you must still connect audio cables to provide sound.
✍ You cannot record signals from equipment connected to the Y, PB, PR
input.