Operating Instructions

14 (US)
Installing and Connecting the TV
IN
OUT
VHF/UHF
AC IN
SUB
WOOFER
CONTROL
S
VIDEO
LR
AUDIO
S VIDEO
VIDEO IN 1
VIDEO IN 2
HD VD
P
B /BY/G P R /R
LR
AUDIO
LR
AUDIO OUT
VIDEO IN 4
LR AUDIO
VIDEO IN 3
DVI-HDTV
Connecting a DVD Player with Component Video
Connectors
This is the preferred hookup to use if:
• Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1 Using three separate component video cables, connect the DVD player’s
Y, B-Y and R-Y jacks to the Y/G, P
B/B and PR/R jacks on the TV. Use
the VIDEO IN 4 connections.
Tip
The Y, B-Y and R-Y jacks on your DVD player are sometimes labeled as Y, CB and CR,
or Y, PB and PR. If so, connect the cables to the matching colors.
2 Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks. Be sure to use the same row of inputs that
you used for the video connection.
Note
Set “Video 4 Mode” to “Y/PB/ PR” in the (Initial Setup) menu (see page 32).
Tips
• To take advantage of the Wide Screen Modes, set the TV’s aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectorsP: Y-Green, P
B
(CB, Cb or B-Y) -Blue and PR (CR, Cr or R-Y) -Red.
VMC-10HG (not supplied)
AUDIO-L (white)
AUDIO-R (red)
DVD player
RK-74A (not supplied)
Rear of TV
P
R/R
P
B/B
Y/G