Help Guide

Table Of Contents

(B) Guidance bar

Note

If the entire angle of the panoramic shot is not achieved within the set time, a gray area occurs in the

composite image. If this happens, move the product faster to record the full panoramic image.

When [Wide] is selected for [Panorama: Size], the entire angle of the panoramic shot may not be achieved

within the given time. If this happens, try shooting after changing [Panorama: Size] to [Standard].

While shooting Sweep Panorama, burst shooting mode is set and the sound of the shutter will be emitted

continuously until shooting ends.

Since several images are stitched together, the stitched part may not be recorded smoothly in some cases.

The images may be blurred in dark scenes.

When a light source such as a fluorescent light flickers, the brightness and color of a stitched image may not

be consistent.

When the whole angle of panoramic shooting and the AE/AF locked angle are very different in brightness

and focus, the shooting may not be successful. If this happens, change AE/AF locked angle and shoot again.

The following situations are not suited for shooting Sweep Panorama:

Moving subjects.

Subjects that are too close to the product.

Subjects with continuously similar patterns, such as the sky, beach, or a lawn.

Subjects with constant change such as waves or water falls.

Subjects with brightness widely different from its surroundings such as the sun or a light bulb.

The Sweep Panorama shooting may be interrupted in the following situations.

When the camera is panned too fast or too slow.

The subject is too blurry.

Hint

You can turn the front dial on the shooting screen to select the shooting direction.